Promotion of Form I′ in the Polymorph Selection of Polybutene-1 during Crystallization under High Gas/Supercritical Fluid Pressure via Enhancing Chain Mobility

Yongna Qiao,Jing Liu,Jinchuan Zhao,Menglong Xu,Qing Qi,Zuolong Chen,Yongfeng Men,Chul B. Park,Patrick C. Lee

DOI: https://doi.org/10.1021/acs.macromol.0c01986

IF: 5.5

2020-11-12

Macromolecules

Abstract:Polybutene-1 (PB-1) always crystallizes into its metastable form II when cooled from a molten state because of its lower nucleation barrier, while the stable form I exhibits superior properties compared to form II, in particular, its resistance to creep and fracture. We investigated the polymorph selection of PB-1 during crystallization under high gas/supercritical fluid (SCF) pressure using a high-pressure chamber and differential scanning calorimeter. By applying pressurized gases/SCFs in PB-1 during crystallization, the obtained crystal form was changed from the kinetically favored metastable form II to the most stable form I′, which is desirable because of its outstanding mechanical properties. The formation of form I′ can also be promoted by increasing the crystallization temperature or by applying gases/SCFs with high solubility in PB-1. The enhancement of chain mobility under high-pressure gases/SCFs and at high crystallization temperatures plays a critical role in the polymorph selection. The increase in chain mobility results in an increase in entropy reduction and an increased surface free energy during nucleation. Therefore, the critical nucleus size required to achieve thermodynamic stability increases, and more entanglement would be needed to form the larger crystal nucleus, which has a greater effect on form II (which has a lower surface free energy under routine conditions) than on form I′. Furthermore, with increased CO2 pressure, we observed a greater reduction in the melting point in form II than in form I/I′. The increase in chain mobility would intensify the local melting in the crystal growth front, where the relaxation of the chains in the interface between the crystal and amorphous phase occurs stronger in the αc-mobile form II. Under high gas/SCF pressure, the formation of form I′ tends to dominate during the crystallization of PB-1, and the crystallization of the kinetically favored form II was suppressed because of the increased chain mobility.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.macromol.0c01986.DSC melting curves of PB-1 in three crystal forms measured at different CO2 pressures (PDF)This article has not yet been cited by other publications.