Abstract:Multilevel inverters with improved voltage quality are widely used in applications such as motor control and electric vehicles. The four-level active neutral point clamped (4L-ANPC) inverter effectively meets the demands for high power density and low device voltage stress. However, balancing the capacitor voltage and reducing its low-frequency voltage fluctuation are critical challenges that need to be addressed. To address these challenges, this paper proposes a "variable reference + zero-sequence injection" method that requires only three reference voltage signals to determine the injected zero-sequence components. Particularly, the expression of the midpoint current, regarding the modulation index and phase current amplitude, is theoretically derived. This reveals the fundamental connection between the zero-sequence voltage signal and the midpoint current, providing a theoretical foundation for the zero-sequence injection method in four-level inverters. Subsequently, a simulation model and an experimental platform of the 4L-ANPC inverter were developed to compare and analyze the waveforms of the upper and lower capacitor voltages, phase currents, and line voltages under different modulation methods. Additionally, the upper and lower capacitor voltage waveforms were examined for various modulation indices. The results indicate that as the modulation index increases, the low-frequency voltage fluctuation in the upper and lower capacitor voltages also rises. At a modulation index of 0.95, the "variable reference + zero-sequence injection" method effectively suppresses the fluctuation in the upper and lower capacitor voltages to be no more than 1 V. These experimental findings validate the effectiveness of the proposed method.

Topology and Voltage-Balance Control of a Single-Phase Active Neutral Point Clamped Seven-Level Inverter

Topology and Control of a Four-Level ANPC Inverter

Seven‐level Boosting Active Neutral Point Clamped Inverter Using Cross‐connected Switched Capacitor Cells

Capacitor Voltage Balancing Algorithm with Redundant Level Modulation for a Five Level Converter with Reduced Device Count

Neutral-Point Potential Balancing of a Five-Level Active Neutral-Point-Clamped Inverter.

Simple Voltage Balancing Control of Four-Level Inverter

The Topologies and Control of Hybrid-Clamped Four-Level and Five-Level Inverters

Two Variations of Five-Level Hybrid-Clamped Converters and Their Voltage Balancing Control Using Three Degrees of Freedom

Common Mode Voltage Reduction and Neutral-Point Voltage Balance for Quasi-Z-Source Three-Level Neutral-Point-Clamped Inverters

Voltage Balancing Control of a Four-Level Hybrid-Clamped Converter Based on Zero-Sequence Voltage Injection Using Phase-Shifted PWM

A Proposed Neutral-Point Voltage Balancing Method for Three-Phase Three-Level T-type Inverter under Non-Unity Power Factor

A hybrid clamped multilevel inverter topology with neutral point voltage balancing ability

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

A Novel Single-Stage Five-Level Common-Ground-Boost-Type Active Neutral-Point-Clamped (5L-CGBT-ANPC) Inverter

Neutral-Point-Clamped Five-Level Inverter With Self-Balanced Switched Capacitor

High Gain Active Neutral Point Clamped Seven-Level Self-Voltage Balancing Inverter

Three-Phase Four-Wire Inverter Topology with Neutral Point Voltage Stable Module for Unbalanced Load Inhibition

Topology and Control of Seven-Level Tree-Type Active Neutral-Point-Clamped Converters

A Fo-Adrc Based Neutral-Point Potential Balancing For Three-Level Inverter

Capacitor Voltage Balancing of a New Five-Level Hybrid-Clamped Inverter

A New Insight on Four-Level Neutral Point Clamped Converters: Four-Level = Two-Level + Three-Level