Abstract:External gear pumps are among the most popular fluid power positive displacement pumps; however, they often suffer from excessive flow pulsation transmitted to the downstream circuit. To meet the increasing demand of quiet operation for modern fluid power systems, it is necessary to give a physically sound method of analyzing the operation of a volumetric pump. The analysis of the basic approach used by the majority of researchers for calculating the flow rate of a gear pump by E.M. Yudin is presented. The article presents a new method for analyzing the operation of volumetric pumps. The method is suitable for the pumps whose dynamic characteristics should be considered according to the model of an equivalent source of flow fluctuations by V.P. Shorin. The method is based on wave theory, the method of hydrodynamic analogies and the impedance method, where the pump is considered according to the model in lumped parameters. The method consists in determining the pressure pulsations at the pump output in bench systems with known dynamic characteristics and recalculating the pump flow rate in pulsations. Computational dynamic models of bench systems in lumped parameters are proposed for subsequent use in dynamic tests of pumps in the form of equivalent sources of fluid flow fluctuations. We give recommendations for the formation of test bench systems with a throttle, a cavity and a pipeline at the pump output. Using the example of an external gear pump with a working volume of 14 cm3/rev, the implementation of the proposed method is considered. The pump's own pulsation characteristic of the flow rate in a bench system with an "infinitely long" pipeline along two harmonic components of the spectrum is determined, and a test of the method based on the method of determining the instantaneous flow rate by R.N. Starobinskiy is proposed. It is shown that, according to the proposed method and the method of R.N. Starobinskiy, the divergence of the amplitudes of flow pulsations does not exceed (5–10)%. The high degree of coincidence of the results confirms that the external gear pump in question should be considered according to the equivalent source of flow fluctuations model.

Comparative Evaluation of Methods for Calculating the Dynamics of Self-Acting Valves in Reciprocating Compressor Units

Study on Flow Field in Capacity Regulating Actuator for Reciprocating Compressor

Valve Plate Roll Analysis on Stepless Capacity Regulation for Reciprocating Compressor

Valve Dynamic and Thermal Cycle Model in Stepless Capacity Regulation for Reciprocating Compressor

Analysis of Rod Reversal in Reciprocating Compressor with Capacity Regulating System

The analysis of the main directions for reducing the intensity of mass flows of the working fluid through leaks in the working chamber of a piston long-stroke low-speed compressor stage

Valve Dynamic Characteristic and Stress Analysis of Reciprocating Compressor Under Stepless Capacity Regulation

Dynamic Performance of Reciprocating Compressor with Capacity Regulation System

Modeling the Work Processes of Slow-Speed, Long-Stroke Piston Compressors

Theoretical assessment of the effectiveness of application single-stage long-stroke piston compressors in refrigeration and hydrocarbon gas liquefaction systems

Analysis of the influence of the ratio of the piston full stroke to its diameter on the working process and characteristics of a reciprocating compressor

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Implementation Features of Multistage Compression in Air Compressor Units Based on Low-Speed Long-Stroke Stages

Modeling the valve dynamics in a reciprocating compressor based on two-dimensional computational fluid dynamic numerical simulation

The analysis of influence of temperature conditions of piston long-stroke compressor stage on thermodynamic efficiency of a heat pump

ExperimentalInvestigationoftheDynamicsofSelfr Actingvalveinareciprocating CompressorforTranscriticalCO2 Refrigeration

Experimental Investigation of the Dynamics of a Self-Acting Valve in a Reciprocating Compressor for Transcritical CO2 Refrigeration.

Dynamic behavior analysis of a moving coil oil-free linear compressor in refrigeration system

Investigation of Flow Behaviour and Heat Rejection for an Air-Cooled Small Multi-Stage Swash-Plate Compressor

New Method to Determine the Dynamic Fluid Flow Rate at the Gear Pump Outlet

The analysis of the effect of piston speed on the operation of a refrigeration compressor operating in the area of wet steam