Abstract:Combustors with fuel-spray atomizers are particularly susceptible to a low-frequency oscillation at idle and subidle conditions. For aeroengine combustors, the frequency of this oscillation is typically in the range 50–120 Hz and is commonly called “rumble.” The mechanism involves interaction between the plenum around the burner and the combustion chamber. Pressure variations in the plenum or the combustor alter the inlet air and fuel spray characteristics, thereby changing the rate of combustion. This in turn leads to local “hot spots” which generate pressure oscillations as they convect through the downstream nozzle. In order to eliminate the combustion oscillations, it is essential to determine which fuel atomizers are particularly likely to lead to instability by quantifying their sensitivity to flow perturbations. This can be done by identifying the system through understanding the transfer function, which represents the relationship between the unsteadiness of combustion and the inlet fuel and air. In the present work, various types of signals are applied to produce a small change in the inlet fuel and air flow rates, the response in the rate of heat release caused downstream was calculated and stored for subsequent analysis. Afterwards, the system transfer function is calculated by determining the coefficients of an IIR filter (Infinite Impulse Response) for which the output signal is the downstream heat release rate and the input signal is the inlet flow rate. The required transfer function then follows from the Fourier transform of this relationship. The resulting transfer functions are compared with those obtained by the forced harmonic oscillations at a fixed given frequency. Suitably chosen input signals accurately recover the results for harmonic forcing at a single frequency, but also give detailed information about the combustor response over a wide frequency range. There are two distinct forms to the low-frequency quasisteady response. In the primary zone, the rate of combustion is influenced by the turbulence and is enhanced when the inlet air velocity is large. Near the edge of combustion zone, the rate of combustion depends on the mixture fraction and is high when the mixture fraction is close to the stoichiometric value. This generates ‘hot spots’ which convect into the dilution zone. At higher frequencies, the combustion lags this quasi-steady response through simple lag-laws and the relevant time delays have been identified.

Detection method of combustion oscillation characteristics under strong noise background

Detecting Oscillations Via Adaptive Chirp Mode Decomposition.

Combustion Instability Detection Based on Multi-Signal Information Fusion for an Industrial Gas Turbine Combustor

Use of Fast Multivariate Empirical Mode Decomposition for Oscillation Monitoring in Noisy Process Plant

Transfer Function Calculations for Aeroengine Combustion Oscillations

Time-Resolved Detection of Multi-Parameter in a Kerosene-Fueled Combustor Using Tunable Diode Laser Absorption Spectroscopy

Time-resolved Multi-Parameter Detection in a Kerosene-Fueled Combustor Using Tunable Diode Laser Absorption Spectroscopy

Analysis And Simulation Of Combustion Oscillations In A Laboratory Spray Combustor

Acoustic Diagnostics Applications in the Study of the Oscillation Combustion in Lean Premixed Pre-Evaporation Combustor

Combustion Control and Symptom Detection on Self-excited Combustion Oscillation

Methods for Simultaneous Measuring Processes of Combustion Oscillations

Oscillation frequency measurement of gaseous diffusion flames using electrostatic sensing techniques

An early detection indicator of combustion instability for an industrial gas turbine combustor

Multidimensional high-temperature field measurement method for flame based on near infrared radiation spectrum of water vapor

In Situ Measurement of NO, NO2, and H2O in Combustion Gases Based on Near/Mid-Infrared Laser Absorption Spectroscopy.

Experimental Investigation on the High-frequency Pressure Oscillation Characteristics of a Combustion Process in a DI Diesel Engine

Flame temperature and heat release rate sensor for active combustion control

Numerical Study on Methods of Passive Control of Thermoacoustic Oscillations in Gas-Turbine Combustors

Experimental detection of two-dimensional temperature distribution in Rocket-Based Combined Cycle combustion chamber using multispectral imaging processing

Study on Passive Control of the Self-excited Thermoacoustic Oscillations Occurring in Combustion Systems

Background Noise Suppress Method for Hydroxyl Tagging Velocimetry in Combustion Flow Field