Abstract:The HC and CO oxidation activity of Pt/Al2O3, Pd/Al2O3 and Pd-Pt/Al2O3 catalysts was compared under three exhaust-gas model conditions typical for stoichiometric gasoline as well as lean burn diesel by means of temperature programed conversion tests on laboratory test benches. In order to understand the differences in emission reduction performance, the impact of gas mixture composition was systematically studied with a particular focus on methane and formaldehyde conversionThe catalysts used in this study were prepared by incipient wetness impregnation of Al2O3 followed by washcoating on ceramic honeycombs, and were pre-treated in an equal manner before each activity test.Distinct differences in pollutant conversion were observed over the three catalysts under the investigated conditions. Pd-based monometallic and bimetallic catalysts revealed the lowest temperature for CH4 oxidation (<450 °C) under lean conditions, being lower under lean Diesel than Compressed Natural Gas (CNG) conditions. The reason for this behavior seems to be the higher water concentration in the CNG gas mixture. Furthermore, it was found that the presence of HCs shift the conversion of methane to higher temperatures, most probably due to produced water during combustion of the HCs. Pt/Al2O3 on the other hand only converts methane at temperatures above 500 °C but no sensitivity to water or the amount of additional HCs was observed. The lowest light-out temperature for formaldehyde oxidation in excess of oxygen was measured on Pt/Al2O3 with full conversion below 125 °C. While this was the case for a model gas mixture of HCHO, H2O and O2, under simulated lean burn gas engine conditions, formaldehyde is oxidized at lower temperature on Pd-Pt/Al2O3 than on Pt/Al2O3 due to the strong inhibiting effect of CO on Pt-particles.Under stoichiometric gasoline conditions, Pt had the highest activity for methane oxidation whereas Pd/Al2O3 and Pd-Pt/Al2O3 hardly convert methane below 500 °C. Unsaturated HCs and CO on the other hand were converted at lower temperature over Pd containing monometallic and bimetallic catalysts in comparison to Pt/Al2O3, showing once again the multiple and complex effects generated by variations in exhaust gas mixture and catalyst composition.

The Effect of Pt/Pd Ratio on the Oxidation Activity and Resistance to Sulfur Poisoning for Pt-Pd/Bea Diesel Oxidation Catalysts with High Siliceous Content

The Effect of Barium Modification on the Sulfur Tolerance of Methane Catalytic Combustion over PdO/Al<sub>2</sub>O<sub>3</sub> Catalysts

The Effect of Barium Modification on the Sulfur Tolerance of Methane Catalytic Combustion over Pdo/Al2o3 Catalysts

Optimizing Pt/Pd Ratios for Enhanced Low-Temperature Catalytic Oxidation of CO and C3H6 on Al2O3 Support

Propene and CO oxidation on Pt/Ce-Zr-SO42-diesel oxidation catalysts:Effect of sulfate on activity and stability

Propene and CO Oxidation on Pt/Ce-Zr-SO 4 2– Diesel Oxidation Catalysts: Effect of Sulfate on Activity and Stability

The Oxidation Performance of a Carbon Soot Catalyst Based on the Pt-Pd Synergy Effect

Promotional effect of ZrO2 and WO3 on bimetallic Pt-Pd diesel oxidation catalyst

Study on the Catalytic Characteristics of Precious Metal Catalysts with Different Pt/Pd Ratios for Soot Combustion

Sulfur Poisoning and NH3 Regeneration of Pt/Al2 O3 : Oxidations of SO2 , NO and C3 H6 as Probe Reactions

Effects of Zr Addition on the Performance of the Pd-Pt/Al 2 O 3 Catalyst for Lean-Burn Natural Gas Vehicle Exhaust Purification

Low-loaded Pt-Pd Diesel Oxidation Catalyst: MnOx Loading Effects

Pt–Pd bimetallic effect in Pt<sub>x</sub>Pd<sub>1−x</sub>/(Ce,Zr,La)O<sub>2</sub> catalysts for NO<sub>x</sub>, HC and CO elimination

Optimization of diesel oxidation catalyst for enhanced emission reduction in engines

Sulfur Poisoning of a Pt/Al2O3 Oxidation Catalyst: Understanding of SO2, SO3 and H2SO4 Impacts

Pt modulates the electronic structure of Pd to improve the performance of Pd-based catalytic combustion catalyst

PGM based catalysts for exhaust-gas after-treatment under typical diesel, gasoline and gas engine conditions with focus on methane and formaldehyde oxidation

Pt/Zeolite Catalysts for Soot Oxidation: Influence of Hydrothermal Aging

Bimetallic CoCu-modified Pt species in S-1 zeolite with enhanced stability for propane dehydrogenation

Unidirectional Electron Transfer on Bismuth-Doped Pt/YMn 2 O 5 for Efficient CO Oxidation as Diesel Oxidation Catalysts

Influence Of Support Acidity On Sulfur Resistance Of Noble Metal Catalysts For Aromatic Hydrogenation Of Diesel Fuel.