Abstract:Confined and submerged two-phase jet impingement offers a compact and effective heat transfer technology for thermal management. In contrast to free-surface jets, few studies have investigated the critical heat flux phenomenon during confined and submerged jet impingement. In this study, the impact of jet velocity on critical heat flux is examined during confined and submerged impingement of a water jet. A single jet issues through a 3.75 mm-diameter orifice and impinges on a circular 25.4 mm-diameter heated surface. The jet velocity is varied between 0.30–1.62 m/s ( Re ≈ 3500–20,000) with the height of the confinement gap held equal to the jet diameter at 3.75 mm. The two-phase flow morphology is observed via high-speed visualization from the top of the confinement gap, and the transient pressure drop across the jet orifice and flow gap is measured simultaneously. Critical heat flux increases monotonically with velocity from 104 W/cm 2 to 275 W/cm 2 over the tested velocity range. As with free-surface jet impingement, two regimes can be identified: a low-velocity regime and a velocity-dominated regime. However, the observed critical heat fluxes for the confined and submerged jet are 32 % to 16 % lower than those predicted for a free-surface jet configuration. This curtailment of critical heat flux is related to disturbances in the incoming liquid flow induced by dynamics of the two-phase flow in the confinement gap, as indicated by large, recorded pressure drop oscillations. These flow and pressure oscillations are attenuated by the jet momentum with increasing velocity, as corroborated by high-speed flow visualizations. In the low-velocity regime, there are significant effects of these two-phase interactions in the confinement gap. Close to critical heat flux, brief periods occur when vapor completely obstructs the jet orifice, during which a significant portion of the heated surface dries out. In the velocity-dominated regime, at higher jet velocities, the two-phase flow disturbances cause observable instances of mild reduction in the flow rate of the incoming liquid jet, which are followed by dry out of small regions on the periphery of the heated surface. Flow visualizations during the transition to film boiling indicate that premature dry out of the heated surface is induced by these flow and pressure oscillations.

Heat Transfer Characteristics of Two-Phase Impinged-Jet Flow and Channel Flow

Flow and Heat Transfer Characteristics in a Microchannel with a Circular Synthetic Jet

Movement of Impingement Heat Transfer by A Single Circular Jet with A Confined Wall

Flow behavior and heat transfer characteristics of liquid film on vertical hot surface by inclined jet impingement

Numerical Study on Heat Transfer of an Impinging Turbulent Plane Jet with Confined Wall.

Two-phase flow and heat transfer on a cylinder via low-velocity jet impact

Experimental and numerical study of heat transfer from a heated flat plate in a rectangular channel with an impinging air jet

Experimental Investigation of Local and Average Heat Transfer Coefficients under an Inline Impinging Jet Array, Including Jets with Low Impingement Distance and Inclined Angle

Experimental Study on Heat Transfer Characteristics of Two-Phase Flow in Square and Rectangular Channels

Transition from Bubbling to Jetting in Submerged Gas-Liquid Jets Through a Minichannel

Heat Transfer and Flow Characteristics of the Jet Array Impingement

Critical heat flux degradation due to flow disturbances and pressure oscillations under confined and submerged two-phase water jet impingement

Heat Transfer Characteristics of a Microchannel Heat Sink with Highly-Dense Micro-Jet Arrays

Numerical Study on Flow and Heat Transfer Characteristics of 3D Turbulent Impinging Jets

Effect of the Nozzle Geometry on Flow Field and Heat Transfer in Annular Jet Impingement

Numerical Investigation and Parameter Sensitivity Analysis on Flow and Heat Transfer Performance of Jet Array Impingement Cooling in a Quasi-Leading-Edge Channel

Numerical Study of the Flow and Heat Transfer of a Rectangular-tube Turbulent Impinging Jet Flow

Experimental and Numerical Investigations of Extended Jet Effects on Multiple-Jet Impingement Heat Transfer Characteristics

Effect Of Narrow Jet Spacing On Impinging Flow And Heat Transfer

Turbulent Heat Transfer From a Slot Jet Impinging on a Flat Plate

Effects of Heat Flux, Mass Flux and Two-Phase Inlet Quality on Flow Boiling in a Vertical Superhydrophilic Microchannel