Abstract:Thermal control of electronic components is a continuously emerging problem as power loads keep increasing. To solve these thermal problems impinging jets are generally used in engineering, science and industry for its good heat transfer performance. In this study; cooling of a flat plate under constant heat flux condition, inside a rectangular channel, consisting of one open and three blocked sides was experimentally and numerically investigated using a single air jet flow. The impingement surface was a copper plate of the same width as the jet nozzle. Inlet flow velocities were measured using a Laser Doppler Anemometer (LDA) system. Temperature measurements were performed using thermocouples. Local and mean Nu numbers were determined as a function of two parameters, (a) Jet-to-plate distance (H/Dh) in the range of 4–10 and (b) Reynolds number based on the hydraulic diameter of the slot nozzle in the range of 4000–10,000 (corresponding to an exit jet velocity from 6.5 to 16.2 m/s). Numerical investigation was also performed. Low Re number k–ε turbulence model was used during investigations. The results are presented in the form of graphs showing the variation of the local Nusselt number as a function of these parameters. The effect of Re number on local Nu number was examined for q″ = 1000 W/m2 and H/Dh = 6. In general, it was observed that heat transfer is sensitive to the Reynolds number and increases with increasing Re number. Average Nusselt number increases of 49.5 % from Re = 4000 to Re = 10000. Effect of H/Dh on heat transfer under impinging air jets was examined with local Nusselt numbers. Local Nusselt number was less sensitive to H/Dh in the range of H/Dh = 4–10. Average Nusselt number decreases of 17.9 % from H/Dh = 4 to H/Dh = 10. The highest average Nu number was achieved for Re = 10,000 and H/Dh = 4. The numerical results agreed well with the experimental data, including local and average Nusselt numbers. Correlations are proposed to predict the local Nusselt number as a function of Re number and H/Dh.

Turbulent Heat Transfer From a Slot Jet Impinging on a Flat Plate

Flow and Heat Transfer Characteristics in a Microchannel with a Circular Synthetic Jet

Numerical Study on Heat Transfer of an Impinging Turbulent Plane Jet with Confined Wall.

Movement of Impingement Heat Transfer by A Single Circular Jet with A Confined Wall

Modelling Of Impinging Flow And Heat Transfer In A Confined Narrow Gap

Free surface planar liquid jet impingement on a moving surface: interfacial flow and heat transfer characteristics

Experimental and numerical study of heat transfer from a heated flat plate in a rectangular channel with an impinging air jet

Local Heat Transfer of a Smooth Flat Plate Impinged by Multiple Jets

Effect of Jet-to-Target Spacing on Flow and Heat Transfer Characteristics for Swirling Impinging Micro-Slot Jets

Flow behavior and heat transfer characteristics of liquid film on vertical hot surface by inclined jet impingement

Effect of Oblique Angle on Flow and Heat Transfer Characteristics of a Turbulent Impinging Slot Jet

Numerical Study on Stagnation Point Heat Transfer by Jet Impingement in A Confined Narrow Gap

Flow dynamics, heat and mass transfer of laminar, round twin-jet impinging a uniformly heated flat plate

Heat transfer and fluid dynamics of a single jet impingement – An experimental and numerical approach

Numerical investigation on conjugate behavior of heat transfer and its augmentation in a turbulent wall-jet flow on a heated plate in motion

Numerical Study on Flow and Heat Transfer Characteristics of 3D Turbulent Impinging Jets

Effects of axial distance on flow behaviours of continuous jet impinging on a flat surface using a finite confined nozzle

The effects of rough surfaces on heat transfer and flow structures for turbulent round jet impingement

Experimental investigation of thermal characteristics of slot synthetic jet impingement on a circular cylinder: Free and constrained environment

Numerical Study of the Flow and Heat Transfer of a Rectangular-tube Turbulent Impinging Jet Flow

Heat Transfer and Flow Characteristics of the Jet Array Impingement