Abstract:The elimination of wet plume is very important in industrial production and daily life. Air mixing method is a common method to eliminate wet plume. However, the design of existing exhaust treatment unit is always based on experience, resulting in higher energy consumption and lower performance. In this paper, it is assumed that air and the exhaust (steam) mixed uniformly and adiabatically in the exhaust treatment unit. The process of eliminating wet plume by air mixing is analyzed theoretically and programmed. In order to verify the accuracy of the calculation program, an air–steam quantitative mixing test bench was set up. The experimental results agree well with the curve of the calculation program. Taking the exhaust parameters of a steam box as an example, the variation law of temperature, relative humidity of mixture and condensate mass flow rate with temperature, relative humidity and mass flow rate of air is analyzed. The results show that higher air temperature, higher air-vapor mixing ratio and lower relative humidity of air are more conducive to the elimination of wet plume. On the premise that no condensate or wet plume is generated, the fitting equation between critical mass flow ratio and ambient temperature and relative humidity is obtained, which provides reference for the design of exhaust treatment device.

Numerical simulation study on the influence of power plant flue gas factors on the formation of white wet plume of flue gas

Ambient air quality impact of emissions from thermal power industry

Theoretical Analysis of Flue Gas Exhaust Temperature of White Smoke Elimination Technology for Coal-fired Units

Formation of White Smoke in Wet Flue Gas Desulfurization Processes and Ways of Prevention

Analysis of the influence of environmental temperature and humidity on the elimination of wet plume by air mixing method

Analysis of Main Influencing Factors of the Wastewater Evaporation in Flue Duct

Simulation Study on Influence of Installation Height of Mist Eliminator on Liquid Holdup of Flue Gas in Desulfurization Tower

Study on Spray Condensation Performance of Desulfurization Wet Flue Gas

Numerical Simulation and Environmental Impact Assessment of VOCs Diffusion Based on Multi-Emission Sources in the Natural Gas Purification Plant

Study on the Effects of Wet Flue Gas Desulfurization on Particulate Matter Emission from Industrial Coal-Fired Power Plants

Experimental Study on Emission Characteristics of Particulate Matters from Wet Flue Gas Desulfurization System of a Coal-fired Power Plant

Study on the Effect of Wet Flue Gas Desulphurization (WFGD) Technology on Flue Gas Particle Emission from Power Plants

Numerical Simulation of the Influence of Air Classifired Combustion Technology on NOx Emissions

Diffusion Characteristics and Mechanisms of Thermal Plumes from Coastal Power Plants: A Numerical Simulation Study

Promoting fine particle removal in double-tower cascade wet flue gas desulfurization system by flue gas temperature reduction

Number simulation of heterogeneous condensation of water vapor on fine particles in growth tube by population balance model

Numerical Simulation of the Combustion and Pollution Emissions from a 75/th Circulation Fluidized Bed Boiler of Power Plant

STUDY ON AFFECTING FACTORS UPON WATER CONSUMPTION IN WET FGD SYSTEM

Numerical simulation of the simultaneous removal of particulate matter in a wet flue gas desulfurization system

Sludge Drying Using Flue Gas and Its Role in Haze Source Control

The effects of sludge drying on removal of particulate matters from flue-gas