Impact of Polymers as Precipitation Inhibitors on Physicochemical Properties of Spray-Dried Astaxanthin-Loaded Self-Microemulsifying Delivery Systems

Wai Thet Aung,Veerakiet Boonkanokwong

DOI: https://doi.org/10.4028/p-8mdb16

2022-03-21

Key Engineering Materials

Abstract:Supersaturated astaxanthin (AST)-loaded self-microemulsifying delivery system (SMEDS) was developed and formulated with polymeric precipitation inhibitors (PPIs) to improve the dissolution profile of AST. Based on our preliminary i n vitro polymer screening test, hydroxypropyl cellulose (HPC-L) and polyvinyl alcohol (PVA8/88) were selected as PPIs and studied further in this work. Microemulsions prepared from AST SMEDS (composed of AST, rice bran oil, Kolliphor ® RH40, and Span ® 20) were mixed with maltodextrin (MD) as a solid carrier and each PPI solution and then solidified using a spray drying technique. Particle size of spray-dried S-MD-HPC powder had larger circular equivalent (CE) diameter (14.69 ± 0.75 μm) than the other formula and showed particle agglomeration in SEM images. Spray-dried S-MD-PVA powder had 8.94 ± 0.37 μm CE diameter, and smooth surface of particles was observed. Amorphous phase transformation and chemical compatibility of both spray-dried powder formulations were detected by FT-IR, PXRD, and DSC. S-MD-HPC had marginally slower dissolution rate and release profile of AST compared to those of S-MD-PVA; however, both HPC and PVA polymers exhibited the ability for AST precipitation prevention and solubilization enhancement. Although AST degradation was caused by high temperature, physicochemical properties of the spray-dried AST SMEDS (S-MD-HPC and S-MD-PVA) powders after reconstitution were not significantly changed upon storage at 30°C/ RH 75%. This study illustrated a novel platform of spray-dried AST SMEDS in combination with HPC or PVA as a polymeric precipitation inhibitor for improvement of AST loading, solubility, and stability.