Abstract:This paper presents a comparison between two design methodologies applied to permanent magnet synchronous machines for hybrid and electric vehicles (HEVs and EVs). Both methodologies are based on 2D finite element models and coupled to a genetic algorithm to optimize complex non-linear geometries such as multi-layer permanent magnet machines. To reduce the computation duration to evaluate Induced Voltage and Iron Losses for a given electrical machine configuration, a new methodology based on geometrical symmetries and magnetic symmetries are used and is detailed. Two electromagnetic models have been developed and used in the design stage. The first model was the stepped rotor position finite element analysis called abc model which considered the spatial harmonics without any approximation of the waveform of flux linkage inside the stator, and the second model was based on a fixed rotor position called dq model, with the approximation that the waveform of flux linkage inside the stator was sinuous. These two methodologies are applied to the design of a synchronous machine for HEVs and EVs applications. Design results and performances are analyzed, and the advantages and drawbacks of each methodology are presented. It was found that the dq model is at least 5 times faster than the abc model with high precision for both the torque and induce voltage evaluation in most cases. However, it is not the case for the iron losses computation. The iron loss model based on dq model is less accurate than the abc model with a relative deviation from the abc model greater than 70% at high control angle. The choice of the electromagnetic model during the optimization process will therefore influence the geometry and the performances of the obtained electrical machine after the optimization.

Exact Modeling and Multiobjective Optimization of Vernier Machines

Analytical Sub-Domain Model for Predicting Open-Circuit Field of Permanent Magnet Vernier Machine Accounting for Tooth Tips

Multi-field Coupling Model of Embedded Giant Magnetostrictive Components Optimization

Modeling and Optimal Design of the Rotary-Linear Type Two-Degree-of-Freedom Ultrasonic Motors

Analytical Model of Electromagnetic Performance for Permanent-Magnet Vernier Machines Using Nonlinear Exact Conformal Model

Sensorless Control Strategy of Novel Axially Magnetized Vernier Permanent-Magnet Machine

Analytical Modeling of A Novel Vernier Pseudo-Direct-Drive Permanent-Magnet Machine

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Analysis and Optimization of Fault Tolerant Permanent Magnet Vernier Rim Driven Machine Based on the Continuous Variable Magnetic Network Model

Nonlinear Analytical Model-Embedded Optimal Design for ER-PMSM

Comparative Analysis and Design Optimization of Ferrite-Based Surface PM Vernier Machines

Dynamic Modeling Of Multi-Axis Synchronous Gantry Machining Center

An Accurate Multi-objective Optimization Strategy for Surface-Mounted Permanent-Magnet Machines Based on Nonlinear Finite-Permeability Subdomain Model

A computationally efficient surrogate model based robust optimization for permanent magnet synchronous machines

Multi-Objective Optimization for the Micro-Milling Process With Adaptive Data Modeling

Design Optimization of Multi-Layer Permanent Magnet Synchronous Machines for Electric Vehicle Applications

Kriging-Assisted Multiobjective Optimization of Embedded Magnetic Encoder in PM Synchronous Machines

Modelling and Design Optimization of a Novel Compliant XY Positioner for Vibration-Assisted CNC Milling

Multi-objective optimization design and experiment for a magnetic micro-vibration isolator considering stiffness trade-offs

Analytical Investigation and Heuristic Optimization of Surface Mounted Permanent Magnet Machines With Hybrid Magnetic Structure

Dynamic Analysis and Optimization of Machine Tool in Consideration of Joint Parameters