Abstract:Structural Health Monitoring, Ahead of Print. This article presents an approach to identify naturally developed damage in low-speed bearings using waveform-similarity-based clustering of acoustic emissions (AEs) under fatigue loading. The approach is motivated by the notation that each recorded AE signal from a particular damage is defined by the convolution of the source signal, transfer function of the propagation path and transfer function of the utilised sensor, and may thusly be used to identify consistent AE sources, for example due to crack growth. A sequential clustering procedure is proposed, that is based on waveform cross-correlation. The supporting theoretical background of waveform similarity, rooted in an analytical formulation of waveform propagation and transmission in complex structures, is discussed. The presented methodology is evaluated through application to AE data obtained in a low-speed run-to-failure experiment utilising a densely instrumented purpose-built linear bearing segment. The implemented sensor system comprises arrays of three types of AE transducers, that is relatively low - (40–100 kHz), mid - (95–180 kHz) and high-frequency (180–580 kHz), that are situated on both the raceways and supporting substructures of either side of the bearing. Over the course of 225,000 cycles of extension and retraction, wear has been developed. A total of about ∼2,300,000 AE signals have been recorded. Analysis of the recorded data suggests the rate of degradation increases from around 70,000 cycles onwards. Highly consistent structures of clusters indicative of a localised defect in the raceway have been identified from around 170,000 cycles onwards. These clusters are characterised by hit-rates in the range of 1–2 hits per cycle and an average similarity of 93%, they comprise about half the AE activity for the periods they have been identified for. These results highlight that the proposed cross-correlation-based clustering of AE waveforms and identification of multi-channel formations in said clusters compose a suitable methodology for assessment of damage in low-speed roller bearings.

Research on early weak structural damage detection of aeroengine intershaft bearing based on acoustic emission technology

Acoustic Feature Enhancement in Rolling Bearing Fault Diagnosis Using Sparsity-Oriented Multipoint Optimal Minimum Entropy Deconvolution Adjusted Method

Application of Acoustic Emission Technique in Diagnosis of Early Rolling Bearing Faults

An adaptive enhanced envelope spectrum technique for bearing fault detection in conditions characterized by strong noise

Fusion Fault Diagnosis Approach to Rolling Bearing with Vibrational and Acoustic Emission Signals

Application of Acoustic Emission Technology for Bearing Condition Monitoring on Passenger Ropeway

Defect Diagnosis for Rolling Element Bearings Using Acoustic Emission

Application Of Acoustic Emission Technique In Diagnostics Of Early Rubbing Fault

Extreme-Low-Speed Heavy Load Bearing Fault Diagnosis by Using Improved RepVGG and Acoustic Emission Signals

Autocorrelated Envelopes for Early Fault Detection of Rolling Bearings

Early Detection of Subsurface Fatigue Cracks in Rolling Element Bearings by the Knowledge-Based Analysis of Acoustic Emission

Acoustic emission monitoring of naturally developed damage in large-scale low-speed roller bearings

Acoustic Emission Signal Feature Extraction for Bearing Faults Using ACF and GMOMEDA

Observation of Time-Frequency Characteristics of the Acoustic Emission from Defects in Rolling Element Bearings

Condition Monitoring of Shaft Crack with Acoustic Emission

Detection of sub-surface damage in wind turbine bearings using acoustic emissions and probabilistic modelling

A high-accuracy intelligent fault diagnosis method for aero-engine bearings with limited samples

Innovative Bearing Fault Diagnosis Method: Combining Swin Transformer Deep Learning and Acoustic Emission Technology

Early Fault Detection of Bearings Based on Adaptive Variational Mode Decomposition and Local Tangent Space Alignment

Rotational Machine Health Monitoring and Fault Detection Using Emd-Based Acoustic Emission Feature Quantification

An early fault warning and diagnosis model based on a two-step analysis strategy for wind turbine bearings