Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Design and development of a laboratory model for generation of dynamic stress in soil

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

The characteristics of dynamic stress in foundation soil cause by train load

Advanced Full-Scale Laboratory Dynamic Load Testing of a Ballasted High-Speed Railway Track

Full scale model tests on slab track constructed on embankment

Dynamic response of circular railway tunnel and track system in saturated soil under moving train loading

Three-Dimensional Simulation of Track on Poroelastic Half-Space Vibrations Due to A Moving Point Load

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Dynamic Response of Railways on Layered Half-Space Subjected to Moving Train Load

Full-Scale Model Testing on A Ballastless High-Speed Railway under Simulated Train Moving Loads

Dynamic Analysis of a Slab Track on the Poroelastic Soil Subjected to Moving Loads

Experimental tests on dynamic behaviors of ballastless track of highspeed railway

Technical Note: Three-dimensional analyses of dynamic responses of track-ground system subjected to a moving train load

Experimental Study of Dynamic Load Magnification Factor for Type I Track-Subgrade System

DYNAMIC RESPONSE ANALYSIS OF TRACK SYSTEM AND UNDERGROUND RAILWAY TUNNEL IN SATURATED SOIL SUBJECTED TO A MOVING TRAIN LOAD

Response of Rail Structure and Circular Tunnel in Saturated Soil Subjected to Harmonic Moving Load

Saturated Ground Vibration Analysis Based on a Three-Dimensional Coupled Train-Track-Soil Interaction Model

Full-Scale Model Testing on Ballasted High-Speed Railway: Dynamic Responses and Accumulated Settlements

Experimental Study on Dynamic Load Magnification Factor for Ballastless Track-Subgrade of High-Speed Railway

Development of an in-situ shaker for evaluating railway earthworks

Soil mechanics principles for modelling railway track performance