Abstract:Hydropower has been the leading renewable source and cheapest ways to generate electrical energy in the world. In recent years, there has been a major upsurge in the hydropower development because of the use of pump as turbine (PAT). However, the operational reliability of a PAT is greatly affected by the unsteady flow fields; therefore, it is important to examine the unsteady flow behavior which can be used as a reference to reduce the noise, vibration, and cavitation performance for centrifugal pumps working as turbines. Thus, the objective of this study was to evaluate the unsteady flow fields by analyzing the distribution of the pressure pulsations using both numerical and experimental measurements in a PAT operating in pump mode. Firstly, the three‐dimensional (3D) unsteady flow equations were solved using SST <i>k‐</i>ω turbulence model during the numerical calculations. Secondly, the numerical results of the hydraulic pump performance were validated by the experimental measurements for numerical accuracy. Lastly, pressure transducers are positioned at certain monitoring points to measure the pressure in the PAT investigated. The numerical and experimental results show that the main frequency of the pressure pulsation is equal to the blade frequency, and as it deviates from the design operating condition, the magnitude of pressure pulsation intensifies. Furthermore, the impeller eye marked the lowest pressure coefficients especially at the design condition and makes it highly susceptible to cavitation. High pressure coefficients were obviously seen at the pressure side on the blade surface closer to the trailing edge at all studied operating conditions. Meanwhile, the rotor‐stator interaction generated the highest pressure pulsation distribution at the volute tongue. Thus, modification of the volute tongue is an optimal approach of reducing the pressure pulsation intensity in the volute and pump as a whole.

Orifice Frequency Dispersion Characteristics Effect on Hydraulic System Pressure Pulsation

Experimental analysis of attenuators in hydraulic circuits

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Investigations on Pulsation-Reduction Characteristics of Hydraulic Attenuator Based on Experimental Method

Pressure pulsation in small opening operating mode of pump turbine’s turbine mode

Experimental Study on Cavitation Resistive Property of Water Hydraulic Throttle Orifices

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

FOULING ANALYSIS ON ENERGY DISSIPATION ORIFICE PLATES WITH SEDIMENT CONTAINED WATER FLOW

Cross influence of rotational speed and flow rate on pressure pulsation and hydraulic noise of an axial-flow pump

Experimental and numerical study of cavitation inside sharp-edged multi-hole orifice plate 1

Influence of Pressure Pulsation on the Performance of Compression System and Turbocharged Engine

Distribution of pressure fluctuations in a prototype pump turbine at pump mode

Research Status, Critical Technologies, and Development Trends of Hydraulic Pressure Pulsation Attenuator

Pressure Drop Of Perforated Orifice In Single-Phase Flow

Strong Pressure Fluctuations at the Rotation Frequency of Hydropower Units

Experimental and Numerical Analysis of Pressure Pulsation in Francis Turbine

Head loss coefficient of orifice plate energy dissipator

Experimental and theoretical studies on the pressure fluctuation of an internal gear pump with a high pressure

Modeling and experiment of pressure drop on valve section of hydraulic oscillator

Effect of pulsating flow on flow-induced vibrations of circular and square cylinders in the laminar regime