Abstract:The goal of this study is to develop a new effective guar gum-grafted acrylamide hydrogel for wastewater treatment, abbreviated as (guar gum-g-acrylamide). For the non-biodegradable and hazardous synthetic acid red 8, the produced guar gum-g-acrylamide hydrogel is a promising thermally stable adsorbent. Microwave-aided technique, ammonium persulfate initiator, and N , N ′-methylene-bis-acrylamide cross-linker are used to make a hydrogel comprising natural polysaccharides guar gum grafted by poly acrylamide. Fourier transformer infrared (FTIR) spectra and scanning electron microscopy (SEM) demonstrate that varied percentages of acrylamide successfully graft the backbone of guar gum. When the grafting percentage of acrylamide is raised, the hydrogel's maximum adsorption capacity (qe) increases. At pH 1 of dye solution, maximum adsorption capacity (qe) is 18 mg.g −1 , at pH 9; qe is decreased up to 8 mg.g −1 . At 0.5 g.L −1 hydrogel, the dye has a low removal percentage (34%), but when the hydrogel dosage is increased to 8 g.L −1 , the removal percentage increases to 90%. When the initial AR8 dye concentration was increased from 50 to 300 mg.L −1 , the removal percentage reduced to 20% and the adsorbed quantity dye increased from 17 to 44 mg.g −1 , but both parameters became limited above this dye concentration. Other ideal conditions for AR8 dye removal by the hydrogel include 60 min of contact time, 150 revolutions per minute (rpm), and a temperature of 20 degrees Celsius. The AR8 dye adsorption kinetic is pseudo-second order, assuming electrostatic interaction between the negatively charged AR8 dye molecules and the positively charged hydrogel-functional group. The adsorption values fit the Langmuir isotherm, with q max . of 54.054 mg.g −1 . The adsorbed quantity (qe) decreases as the temperature rises, indicating that dye molecules physisorbed on the hydrogel pores, and the maximum adsorption capacity is at 20 °C. The exothermic and spontaneity of adsorption were confirmed by the negative values of heat of adsorption (∆ H ° ads. ) and standard Gibbs free energy of adsorption (∆ G ° ads. ). The reusability of the hydrogel was validated after three cycles of desorption of AR8 dye from the hydrogel surface in alkaline solution.

Removal of anionic dyes with glycidyl methacrylate-grafted polyethylene terephthalate (PET) fibers modified with ethylenediamine

Synthesis of new sustainable polyester‐type hydrogels from chemical recycled poly(ethylene terephthalate) products applied on the removal of indigo carmine dye

Preparation of New Hydrophilic PET Fiber by Grafting with Acrylic Acid and Modification with Amino Groups for Improvement of Dyeing Ability

Highly Porous Poly(o-Phenylenediamine) Loaded Magnetic Carboxymethyl Cellulose Hybrid Beads for Removal of Two Model Textile Dyes

Studying removal of anionic dye by prepared highly adsorbent surface hydrogel nanocomposite as an applicable for aqueous solution

Effective removal of malachite green dye by eco-friendly pectin-grafted poly(acrylamide-co-sodium acrylate) hydrogel from aqueous solutions

Efficient Decontamination of Cationic Dyes from Synthetic Textile Wastewater Using Poly(acrylic acid) Composite Containing Amino Functionalized Biochar: A Mechanism Kinetic and Isotherm Study

Preparation and adsorption behavior of diethylenetriamine/polyacrylonitrile composite nanofibers for a direct dye removal

Preparation of a surface modified fly ash-based geopolymer for removal of an anionic dye: Parameters and adsorption mechanism

Highly efficient and selective removal of anionic dyes from aqueous solutions using polyacrylamide/peach gum polysaccharide/attapulgite composite hydrogels with positively charged hybrid network

New and innovative microwave-assisted technology for synthesis of guar gum-grafted acrylamide hydrogel superabsorbent for the removal of acid red 8 dye from industrial wastewater

Melting-reactive dyes for mass coloration of synthetic fibres—part I: perylene-3,4,9,10-tetracarboxylic acid dianhydride in poly(ethyleneterephthalate)

Removal of Methylene Blue Dye from Wastewater Using Polydopamine Agave Americana Fibres-co-Poly(AAc)/Ag Nanocomposites

Grafting 3-trimethoxysilylpropyl)diethylenetriamine on microcrystalline cellulose for the adsorption of dyes: Experimental and modeling studies

Synthesis of p(HEMA-co-AETAC) nanocomposite hydrogel with vinyl-function montmorillonite nanoparticles and effective removal of methyl orange from aqueous solution

Aminated Polyacrylonitrile Nanofiber Membranes for the Removal of Organic Dyes

Depolymerization of PET Fibers from Textile Blends and Recovery of Terephthalic Acid

A New Solid Phase Extractor Based on Cross-linked PMMA@CNTs/GNP for the Removal of Crystal Violet and Methylene Blue Dyes

Facile synthesis and ultrastrong adsorption of a novel polyacrylamide-modified diatomite/cerium alginate hybrid aerogel for anionic dyes from aqueous environment

Removal of Methylene Blue and Basic Yellow 28 Dyes from Aqueous Solutions Using Sulphonated Waste Poly Methyl Methacrylate

Influence of Monomer Composition in the Electron Beam Graft Polymerization Condition Onto PET Fabrics