Abstract:Static compensators (STATCOMs) are often used in distribution systems to enhance power quality. There is a need to enhance the performance of STATCOM to optimize its utilization and facilitate the provision of additional ancillary services. This paper employs the multilayer discrete noise-eliminating second order generalized integrator (MDNESOGI) to regulate the quasi-impedance source inverter (qZSI)-STATCOM for power exchange with the grid. Compared to conventional second-order generalized integrator (SOGI), MDNESOGI exhibits a higher capability for rejecting DC offset. In instances of abnormal grid operation or system malfunction, the inclusion of DC rejection capability enhances the robustness and reliability of the system. The suggested control algorithm only requires two integrators, three mathematical operators, and a damping factor, making it far easier to implement than transformation-based methods. The distorted load current is broken down into its active and reactive components using this control mechanism. The reference currents are then calculated by multiplying these parts by their corresponding voltage standards. The DC offset is reduced and transient oscillations in the weight component are eliminated by adjusting the damping factor. The suggested algorithm effectively handles power quality tasks like (a) reducing harmonic distortion, (b) compensating for reactive power, (c) adjusting for power factor, and (d) balancing the load under different conditions in the distribution system. The experimental study results are used to examine the stability of the proposed control scheme in both static and dynamic scenarios. In addition, a comparison to traditional methods is provided to demonstrate the new method's superiority. Experimentation results show that the suggested controller is superior to its contemporaries in all scenarios where power quality is a factor, meeting the IEEE standard requirements.

Experimental verification of STATCOM based on quasi impedance source inverter for power quality enhancement in the hybrid distributed generation system

Feed-forward Control of STATCOM with Harmonic Voltage in Power Grid

Analysis, Control and Optimal Placement of Static Synchronous Compensator With/without Battery Energy Storage

Photovoltaic-Based q-ZSI STATCOM with MDNESOGI Control Scheme for Mitigation of Harmonics

A Hybrid STATCOM Approach to Enhance the Grid Power Quality associated with a Wind Farm

Cascade STATCOM Application in Voltage Stability of Grid-Connected Wind Farm

A Review of STATCOM Control for Stability Enhancement of Power Systems with Wind/pv Penetration: Existing Research and Future Scope

STATCOM Based on Modularized Multilevel Converters

Intelligent Parameter Design-Based Impedance Optimization of STATCOM to Mitigate Resonance in Wind Farms

Control and Simulation of STATCOM Integrated Energy Storage System

Design and real-time validation of PI and Fuzzy Logic tuned photovoltaic integrated DSTATCOM to improve power quality

Wind Generator Output Power Smoothing and Terminal Voltage Regulation by Using STATCOM/ESS

Stabilization of Wind Turbine Generator System by STATCOM

Improvement of Power Quality and Dynamic Voltage of Wind Farms Using an Inductive Filtering Method

Research on 35kv Cascaded Statcom and ITS Application

Study of STATCOM on Reactive Power Compensation Strategy of Wind Farm

Impedance Shaping Control for STATCOM to Improve the Stability of Wind Farm Systems

STATCOM Impact Study on the Integration of a Large Wind Farm into a Weak Loop Power System

A Novel STATCOM Based on Cascaded Three-phases Voltage Source Inverter

Power Quality Improvement by using a STATCOM Control Scheme for Grid Connected Wind Energy System

Application of STATCOM/BESS for wind power smoothening and hydrogen generation