Abstract:Surface integrity is important to improve the fatigue property of components. Proper selection of the cutting parameters is extremely important in ensuring high surface integrity. In this paper, ball end milling of TC17 alloy has been carried out utilizing response surface methodology. The effects of cutting speed, feed per tooth, cutting depth, and cutting width on the surface integrity characteristics, including surface roughness ( R a ), surface topography, residual stress, and microstructure were examined. Moreover, predictive metamodels for surface roughness, residual stress, and microhardness as a function of milling parameters were proposed. According to the experimental results obtained, the surface roughness increases with the increase of milling parameters, the ( R a ) values vary from 0.4 μm to 1.2 μm along the feed direction, which are much lower compared to that along the pick feed direction. The surface compressive residual stress increases with the increase of feed per tooth, cutting depth, and cutting width, while that decreases at high cutting speed. The depth of the compressive residual stress layer is mostly in the range of 25–40 μm. The milled surface microhardness represents 6.4% compared with the initial state; the work-hardened layer depth is approximately 20 μm. Moreover, plastic deformation and strain streamlines are observed within 3 μm depth beneath the surface. The empirical model of surface integrity characteristics is developed using the results of ten experiments and validated by two extra experiments. The prediction errors of the three surface integrity characteristics are within 27%; the empirical model of microhardness has the lowest prediction errors.

Effect of surface roughness on the fatigue failure and evaluation of TC17 titanium alloy

Surface Characteristics and Roughness Prediction of TC4 Titanium Alloy in High Speed Grinding

Effect of Cutting Surface Integrity on Fatigue Properties of TC17 Titanium Alloy

Research on Surface Integrity and Fatigue Properties in the Turning of TC17 Titanium Alloy Based on the Response Surface Method

The effect of surface roughness and microstructure on fretting fatigue properties of TC21 based on hierarchical multiscale modeling

High cycle and very high cycle fatigue of TC17 titanium alloy: Stress ratio effect and fatigue strength modeling

Effects of defects on fatigue behavior of TC17 titanium alloy for compressor blades: Crack initiation and modeling of fatigue strength

Fatigue life analysis for 6061-T6 aluminum alloy based on surface roughness

High-temperature fatigue behavior of TC17 titanium alloy and influence of surface oxidation

The Fatigue Deformation Mechanism of TC17 Alloy with Residual Stress and Microstructure Dual Gradients

Numerical simulation of surface roughness effects on low-cycle fatigue properties of additively manufactured titanium alloys

Understanding the Relations between Surface Stress State and Microstructure Feature for Enhancing the Fatigue Performance of TC6 Titanium Alloy

Surface Condition Evolution and Fatigue Evaluation after Different Surface Processes for TiAl47Cr2Nb2 Alloy

Study on Surface Integrity and Fatigue Properties of TC4 Titanium Alloy by Surface Ultrasonic Rolling

A new combined impact fatigue damage model and its application of influencing factors analysis on impact fatigue of TC18 titanium alloy

Prediction model of surface integrity characteristics in ball end milling TC17 titanium alloy

Effect of Surface Roughness and Compressive Residual Stress on the Fatigue Performance of TC4 Titanium Alloy Subjected to Laser Shock Wave Planishing

Experimental Study on Forged TC4 Titanium Alloy Fatigue Properties under Three-Point Bending and Life Prediction

Effect of Surface Integrity on Hot Fatigue Life of Ti2AlNb Intermetallic Alloy

The Effect of Defect Characteristics on Prediction of Fatigue Life of TC4 Titanium Alloy Welded Joints

Fatigue cracking behavior and life assessment of TC11 titanium alloy in very high cycle regime at two working temperatures