Optimization of parameters for sugarcane lifter based on simulation of virtual prototype
Jinbing Hu,Jun Wang,Ying Hu
DOI: https://doi.org/10.3785/j.issn.1008-9209.2014.01.013
2014-01-01
Abstract:In the southern China , the sugarcane is mostly planted on the slopes and hilly areas . Because of the influence caused by the typhoons and monsoons , the sugarcane always render in the state of lodging and bending . Lifting up the sugarcane is the first step of the mechanized harvesting of sugarcane . It is demanded that the harvest mechanic of sugarcane should be adapt to the planting patterns and growth condition , in order to lift up the sugarcane in different lodging status . Currently , the design and the research method on sugarcane lifter was traditional , which usually did static analysis only and did not take the dynamic characteristics into consideration . The propped effect of the existing mechanism is poor and the efficiency is not really high , meanwhile , the sugarcane lifter has problems caused by the unreasonable structure design and operation parameters . In order to solve these problems , the virtual prototype technology will be used to do the virtual experiment on sugarcane lifter .At the same time , the technology will also analyze its key technology , save the cost of physical prototype research and development , and shorten the development cycle of the physical prototype as well . The investigated subject of this paper was mainly the sugarcane lifter with the 60° installation angle and the equivalent pitch spiral . Aimed at the problems of the sugarcane lifting caused by the unreasonable structure design and the operation parameters , the three-dimensional model would be imported into the ADAMS software to do the dynamic simulation . The method of three levels and three factors comprehensive test was used , whose impact factors were sugarcane lifter speed , pitch and the forward speed . Regarding the lifting height as the evaluation index , it intended to find the optimum combination for the virtual experiment of the sugarcane lifter structure and the working parameters , meanwhile , the test data variance would be analyzed by the MATLAB software . Through the analysis of the dynamic simulation of the sugarcane lifter , it was clear that when the time was 0 to 1.5 s , the sugarcane lifter would not get in touch with the sugarcane , and as a result , the centroid vertical displacement was not changed accordingly ;but when the time was 1.5 to 4.5 s , the sugarcane would be lifted by the sugarcane lifter , and the centroid vertical displacement was correspondingly increased gradually . When the time was more than 4.5 s , the fluctuations of the centroid vertical displacement would come out because of the non-existence of the simulation of cutting part.In the combination of the ADAMS virtual comprehensive test , the best operating and structure parameters for the angle of 60° installation sugarcane lifter was that :when the speed of the sugarcane lifter was up to 120 r/min , the pitch of thread was 360 mm , and the forward speed was 350 mm/s , the lifting height of the 60° side lodging sugarcane would reach the maximum 186.9 mm . In addition , the three factors have mutual interactions with each other , and this moment was the strongest time that the forward speed affected the height of the sugarcane lifter , all of which will eventually provide the theory basis for the improvement of sugarcane lifter .