Abstract:In order to improve the lightweight level of the automotive floor, reduce material application cost, and improve integrated process manufacturing performance through structural design and optimization, this article proposes a design method to link conceptual design and detailed design and optimize the composite floor by combining free size optimization and size optimization methods. The basic theory of composite mechanics is expounded from the stress-strain theory of single-layer plates, and the stiffness and strength theory of laminated plates, which provides theoretical support for the structural design, material design, and allowable value design of composites. The mechanical properties of CFRP were tested to obtain the basic material parameters of CFRP T300/5208. With the material parameters, the CFRP floor super layers are established in Optistruct software. The shape of the floor super layers is optimized by using the free size optimization method, with the body-in-white (BIW) lightweight coefficient as the objective and the BIW performance as the constraints. The BIW lightweight coefficient is reduced from 4.35 to 4.20 after free size optimization, and the layer blocks shape is obtained and clipped based on engineering application. With the floor mass as the objective and the BIW performance as the constraints, the size optimization of the floor layer blocks thickness is optimized. Then the number of floor layers is obtained, and the CFRP floor is established in Fibersim software. Use the simulation analysis method to compare and verify the performance of the floor before and after optimization. The results show that the failure index of the floor is far less than the failure standard, while the mass of the CFRP floor is reduced by 6.8 kg compared with the original steel floor, which an improvement rate reaching 27.5%. The design and optimization methods presented in this article provide a reference for the design and application of the CFRP floor.

New Design of Composite Structures Used in Automotive Engineering

Multi‐Disciplinary Design Optimization of a Composite Car Door for Structural Performance, NVH, Crashworthiness, Durability and Manufacturability

Optimal Design and Testing of a Thermoplastic Pressurized Passenger Door Manufactured Using Thermoforming

Material Selection for Lightweight Design of Vehicle Component

Research on the use of lignocellulosic fibers reinforced bio-polyamide 11 with composites for automotive parts: Car door handle case study

Advances of Composite Materials in Automobile Applications – A Review

Towards composite suspension control arm: Conceptual design, structural analysis, laminate optimization, manufacturing, and experimental testing

Composites from Recycled Polypropylene and Carboxymethylcellulose with Potential Uses in the Interior Design of Vehicles

Economic Analysis of Two Different Door Architectures

Design, Analysis and Optimization of Car Door

OPTIMIZATION OF CAR DOOR HANDLE USING HONEYCOMB STRUCTURE AND 3D PRINTING TECHNOLOGY

Production and Assembly of Car Body Fifth Door with Use of Dual-Phase Steel HCT500X

Explorative Study on the Use of Curauá Reinforced Polypropylene Composites for the Automotive Industry

Optimization and Experimental Testing of Car Door Handle Using 3 Point Bending Test and 3D Printing Technology

Study of injection molding process simulation and mold design of automotive back door panel

Experimental and numerical studies on bending characteristics of woven CFRP reinforced aluminum thin-walled automotive structures

Inverse Fiber Reinforced Polymer/Metal-Hybrid Laminates for Structural Lightweight Applications

Application Research on the Lightweight Design and Optimization of Carbon Fiber Reinforced Polymers (CFRP) Floor for Automobile

Composite material: A review over current development and automotive application

Computational Analysis of Mechanical Properties in Polymeric Sandwich Composite Materials

Mechanical properties study on sandwich hybrid metal/(carbon, glass) fiber reinforcement plastic composite sheet