Abstract:We demonstrate a novel transmission color filter design that exploits both dielectric and plasmonic resonances to establish a highly color-selective device, reaching an experimental full-width at half-maximum (fwhm) that is only half that of previously demonstrated cost-effective color filter devices for the same peak transmission and better out-of-band rejection. The measured fwhm is only 25 nm, and the peak transmission reaches up to 53%. The filter uses the interference of Fabry-Pérot resonances and guided-mode resonances in two separated dielectric slabs to achieve this excellent fwhm while relying on propagating surface plasmon polaritons to achieve the excellent out-of-band rejection. A simulation study elucidates the nature of the optical modes in the device and their interference mechanisms and reveals the most important design considerations. Fabrication was done in a CMOS pilot line and is cost-effective, as it requires only two metal patterning steps. Fabrication imperfections are discussed, together with strategies to mitigate them. We show the correct mitigation of these imperfections leads to further performance gain, enabling a full-width at half-maximum down to 20 nm and a peak transmission beyond 60%. We believe this novel filter design is a powerful concept to improve the spectral resolution of color filters for cost-effective multispectral imaging. Beyond multispectral imaging, the design could be adapted for other applications that require on-chip spectral filtering in a thin form factor.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsphotonics.1c01983.Table with dimensions of optimized unit cell designs for different pitches; Transfer matrix method applied to separate SiN sections to isolate Fabry-Pérot resonances; Simulated and measured transmission spectra for the orthogonal polarization (electric field parallel with the grating lines); Simulated transmission spectra for nonzero angle of incidence; Refractive index and extinction coefficient extracted from ellipsometry measurement (PDF)This article has not yet been cited by other publications.

Tunable optical filters with hybrid plasmonic-dielectric thin-films for fluorescence sensing

Electrostatically Tuned Optical Filters Based on Hybrid Plasmonic-Dielectric Thin Films for Hyperspectral Imaging

Highly Efficient Omnidirectional Structural Color Tuning Method Based on Dielectric-Metal-dielectric Structure.

A Programmable Optical Filter with Arbitrary Transmittance for Fast Spectroscopic Imaging and Spectral Data Post-Processing.

A High Throughput Tunable Filter Module for Multispectral Imaging

Tunable Optical Thin Film Filter Array Based on the Microstructure Technique

Tailoring TiO2/Al2O3 Heterolayers As Optical Filters for the Visible Region

Tunable Terahertz Metamaterial with Electromagnetically Induced Transparency Characteristic for Sensing Application

Lab-on-chip module for fluorescence detection

Highly Selective Color Filters Based on Hybrid Plasmonic–Dielectric Nanostructures

Multi-Narrowband Tunable Plasmonic Induced Transparency for Sensing

Plasmonic Nanoresonators for High-Resolution Colour Filtering and Spectral Imaging.

Narrowband wide dynamic range tunable filter based on Fano resonant planar multilayered structure

Broad-tuning, Dichroic Metagrating Fabry-Perot Filter Based on Liquid Crystal for Spectral Imaging

Optofluidic tunable filters using ionic liquid electrolyte capacitors

Optical Sensing Using Hybrid Multilayer Grating Metasurfaces with Customized Spectral Response

Design and performance analysis of a highly sensitive photonic crystal fiber based plasmonic sensor

All-optical continuous tuning of phase-change plasmonic metasurfaces for multispectral thermal imaging

Optofluidic photonic crystal fiber platform for sensitive and reliable fluorescence based biosensing

A Multi‐Resonant Tunable Fabry‐Pérot Cavity for High Throughput Spectral Imaging

Nanostructured Metal-Insulator-metal Resonators for High-Resolution Color Filtering and Spectral Imaging