Abstract:Permanent deformation is a long-term irrecoverable depression accumulated in the wheel path when the flexible pavement is subjected to heavy loads at high temperature, which can be simulated using the vertically loaded wheel test (VLWT) in the laboratory. The objective of this study is to develop a new approach to analyze the vertically loaded wheel test results based on the elastic-viscoelastic correspondence principle. The energy-based pseudo variables are proposed to perform rutting evaluation of asphalt mixtures in the VLWT.Four types of styrene-butadienestyrene modified asphalt mixtures were prepared to conduct the undamaged compressive dynamic modulus test at different temperatures. Then the master curves of dynamic modulus for these mixtures were converted to get the relaxation modulus. The innovative VLWT for four types of two-layer structure with different asphalt mixture combinations were performed to investigate the rutting development. After that, a new mechanical-empirical rutting prediction model was introduced to predict the rutting development for each layer in the two-layer structure. The energy-based pseudo variables including pseudo strain, pseudo strain rate and dissipated pseudo strain energy (DPSE) were introduced to correlate with the rutting resistance.The results show that the developed mechanical-empirical rutting prediction model is proficient in capturing the rutting development of a two-layer structure of asphalt mixtures measured by a vertically loaded wheel tester. The rutting contributions of the top and bottom layers can be separated using this model. Compared with the total strain, the pseudo strain which removes the viscoelastic effect, is more accurate to evaluate the permanent deformation in a cyclic loading condition. The DPSE increases with the increase of loading cycles and rut depth. Two typical stages with an inflection point can be observed from the test results which indicate that the faster to reach the inflection point, the better rutting performance will be achieved.

Research on the high temperature performance of asphalt pavement based on field cores with different rutting development levels

Evaluation of Crumb Rubber Modification and Short-Term Aging on the Rutting Performance of Bioasphalt

Research on Preparation and High Temperature Behavior of High-Modulus Asphalt

Research on High- and Low-Temperature Rheological Properties of High-Viscosity Modified Asphalt Binder

Nonlinear Viscoelastoplastic Kinetics for High-Temperature Performance of Modified Asphalt Binders

Study On Dynamic Response Characteristics Of Saturated Asphalt Pavement Under Multi-Field Coupling

High-Temperature Rheological Characteristics of Asphalt Binder Incorporated with Graphene Oxide and Predicting Its Rutting Potential Using Response Surface Method

Study on High Temperature Performance of Asphalt Mixture Based on Rutting Test

Research on High-Temperature Evaluation Indexes and Performance of Qingchuan Rock-SBS Composite Modified Asphalt

Influence of temperature and humidity coupling on rutting deformation of asphalt pavement

Analysis of primary influencing factors and indices distribution law of rutting performance of asphalt mixtures

Analysis of Coupling Effect and Heavy Load of High-Temperature Stability of Asphalt Mixture

Evaluation of Rutting Potential of Flexible Pavement Structures Using Energy-Based Pseudo Variables

Long-Term Field Rutting and Moisture Susceptibility Performance of Warm-Mix Asphalt Pavement

Evaluation of factors that affect rutting resistance of asphalt mixes by orthogonal experiment design

Design of High-Modulus Asphalt Concrete for the Middle Layer of Asphalt Pavement

Study on the Road Performance of Foamed Warm-Mixed Reclaimed Semi-Flexible Asphalt Pavement Material

Laboratory and Field Investigation of the Feasibility of Crumb Rubber Waste Application to Improve the Flexibility of Anti-Rutting Performance of Asphalt Pavement

Finite element analysis of rutting on full depth asphalt pavement in port area considering temperature field

Structural layer applicability of semi-flexible material for rutting resistance: A coupled temperature-mechanical approach

Long-Term Service Performance of Hard-Grade Asphalt Concrete Base Pavement Based on Accelerated Loading Test of Full-Scale Structure