Abstract:The vector control of the permanent magnet synchronous motor (PMSM) is affected by cross-coupling, output delay, parameter mismatch, and other factors; thus, resulting in its poor steady-state and insufficient dynamic performance. To address these problems, the design proposed in this study adopts a model predictive current control strategy. In the traditional model predictive control, the absolute value of the difference between the predicted output current of the inverter and the reference current is used as the cost function instead of the minimum value of the valence function, i.e., the optimal solution of the system, and the best switching state is outputted. The design proposed in this study adopts the dual-vector model to predict the current control. Firstly, the reference voltage vector was predicted on basis of the deadbeat idea, which reduced the calculation burden of processor. Next, in order to further improve the stability of the system, a two-vectors duty cycle calculation method was introduced. Then, simplifies the selection range of the two voltage vectors. While ensuring the accuracy of the voltage vector, the control is reduced. Reduce the amount of calculation in the system, thereby improving its robustness. Finally, based on the principle of current vector tracking error minimization, the duration of the selected voltage vector was determined. Last but not the least, the control strategy is applied to the MTPA control to increase the operating efficiency of the control motor. The improved control strategy can effectively reduce the torque ripple and improve the dynamic and steady-state performance of the system. Simulation results verify the feasibility and effectiveness of the proposed control algorithm.

Hybrid Decision Based on DNN and DTC for Model Predictive Torque Control of PMSM

Current Control for PMSM Based on Model Predictive Control with Automatic Differentiation

Neural-Network-Based Predictive Control for PMSM Drives

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

An Error Tracking Dead-beat Model Predictive Torque Control for Open-Winding Permanent Magnet Synchronous Motor with Common DC Bus

A Modified Deadbeat Predictive Current Control with Improved Dynamic Performance under Insufficient Voltage Margin for IPMSM

Deadbeat Model-Predictive Torque Control With Discrete Space-Vector Modulation for PMSM Drives

An Improved Model Predictive Torque Control for PMSM Drives Based on Discrete Space Vector Modulation

Model Predictive Current Control with Adaptive-Adjusting Timescales for PMSMs

A Novel Torque Ripple Reduction Strategy for Predictive Direct Torque Controlled Pmsg

Model predictive flux control for permanent magnet synchronous motor

Computationally efficient multi‐step direct predictive torque control for surface‐mounted permanent magnet synchronous motor

Direct Torque Model Predictive Control of a Five-Phase Permanent Magnet Synchronous Motor

MTPA control of permanent magnet synchronous motor based on dual-vector model predictive control

Predictive Torque Control for PMSM Based on Weighting Factor Elimination and Fast Voltage Vector Selection

Efficient Predictive Control for Dual Three-Phase PMSM Drive With Vector Transformation

Finite Control Set Model Predictive Torque Control With Reduced Computation Burden for PMSM Based on Discrete Space Vector Modulation

Predictive DTC Strategy With Fault-Tolerant Function for Six-Phase and Three-Phase PMSM Series-Connected Drive System

Model Predictive Direct Duty-Cycle Control for PMSM Drive Systems With Variable Control Set

Torque Ripple Reduction of the Torque Predictive Control Scheme for Permanent-Magnet Synchronous Motors