Abstract:Objective: To describe the process of three-dimensional printing in epilepsy surgery using three different methods: low-force stereolithography (SLA), filament deposition modeling (FDM), and Polyjet Stratasys, while comparing them in terms of printing efficiency, cost, and clinical utility. MRI and CT images of patient anatomy have been limited to review in the two-dimensional plane, which provides only partial representation of intricate intracranial structures. There has been growing interest in 3D printing of physical models of this complex anatomy to be used as an educational tool and for surgical visualization. One specific application is in epilepsy surgery where there are challenges in visualizing complex intracranial anatomy in relation to implanted surgical tools. Methods: MRI and CT data from patients with refractory epilepsy from a single center that underwent surgery are converted into 3D volumes, or stereolithography files. These were then printed using three popular 3D printing methods: SLA, FDM, and Polyjet. Faculty were surveyed on the impact of 3D modeling on the surgical planning process. Results: All three methods generated physical models with an increasing degree of resolution, transparency, and clinical utility directly related to cost of production and accurate representation of anatomy. Polyjet models were the most transparent and clearly represented intricate implanted electrodes but had the highest associated cost. FDM produced relatively inexpensive models that, however, were nearly completely opaque, limiting clinical utility. SLA produced economical and highly transparent models but was limited by single material capacity. Significance: Three-dimensional printing of patient-specific anatomy is feasible with a variety of printing methods. The clinical utility of lower-cost methods is limited by model transparency and lack of multi-material overlay respectively. Polyjet successfully generated transparent models with high resolution of internal structures but is cost-prohibitive. Further research needs to be done to explore cost-saving methods of modeling.

Clinical application of patient-specific 3D printing brain tumor model production system for neurosurgery

Three dimensional printing technology in neurosurgery

Application of 3D-Printed Craniocerebral Model in Simulated Surgery for Complex Intracranial Lesions

Development of Three-Dimensional Printed Craniocerebral Models for Simulated Neurosurgery.

3D-Printed Disease Models for Neurosurgical Planning, Simulation, and Training

Step-by-Step Implementation of Three-Dimensional Print Technology in Preoperative Neurosurgery Planning

Comprehensive insight into 3D bioprinting technology for brain tumor modeling

Advancing 3-Dimensional Printed Burr Hole and Craniotomy Models for Neurosurgical Simulation Through Multimaterial Methods

3D Printing-Assisted Skull Base Tumor Surgeries: An Institutional Experience

Three-dimensional Printing in Neurosurgical Planning of Skull Base Surgery

Preparation of Simulate Craniocerebral Models Via Three Dimensional Printing Technique

3D Printing Technology-Assisted Endoscopy Surgery in the Treatment of Skull Base Tumors : A retrospective study

The manufacturing procedure of 3D printed models for endoscopic endonasal transsphenoidal pituitary surgery

3D Bioprinted Hyaluronic Acid-Based Cell-Laden Scaffold for Brain Microenvironment Simulation

A neurosurgical simulation of skull base tumors using a 3D printed rapid prototyping model containing mesh structures

Production and Clinical Application of 3D Printing Models of Intracranial Aneurysms

Using Three-Dimensional Printing to Create Individualized Cranial Nerve Models for Skull Base Tumor Surgery

Application of 3D printed model for planning the endoscopic endonasal transsphenoidal surgery

Three-Dimensional Printing in Neurosurgery: A Review of Current Indications and Applications and a Basic Methodology for Creating a Three-Dimensional Printed Model for the Neurosurgical Practice

A feasibility study of several 3D printing methods for applications in epilepsy surgery

Virtual Surgical Planning and Pre-operative Simulation for Maxillofacial Reconstruction with 3D Printing Technology in Tumor-affected Facial Deformity