Abstract:This paper describes the use of video and digital image processing in investigation of the impact between a rigid hemispherical shape impactor and Hybrid Polyurea-Polyurethane-MWCNTs Nanocomposite Coatings. An experimental study was performed for six sample configurations: single aluminum plates (reference test), multilayer plates with 4 types of coatings and double aluminum plates. The impact phenomenon was recorded with a high-speed video camera and the variation of the projectile s velocity during the impact was obtained through digital analysis. Additionally, the test was instrumented using a force sensor specially designed and mounted on the impactor. The video processing was used to draw the velocity curves and to estimate the evolution of the contact forces between the impactor and the multilayer structures, the results obtained being compared with the force sensor data. Some differences between these two types of measurements are observed, so in order to analyze the configurations behavior, a numerical study of the phenomena was performed in LS-DYNA software using a 2D axial symmetric model. The simulations showed that the profile of the force evolution measured with the sensor is affected by the chosen constructive solution and the data obtained based on the video images are more accurate. The deformations were analyzed, the maximum deformation based on image processing and the residual deformation based on 3D Scan post-test. The video technique combined with 3D Scan are precise enough to study the impact at low velocities and the numerical simulations provide results according to reality. The hyperelastic coatings contribute to a better resistance of the aluminum plates.

Experimental analysis of impacts with large elastic deformation: I. Linear motion

Development of Structural Testing Equipment for Impact and Complex Loading

NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS

Full-field Dynamic Response of Low-Velocity Impact on an Elastic Plate Using 3D Digital Image Correlation

Geometric Nonlinear Effects on the Planar Dynamics of A Pivoted Flexible Beam Encountering A Point-Surface Impact

Experimental and Theoretical Study of Free–free Beam Subjected to Impact at Any Cross-Section along Its Span

Dynamic Modeling of a Flexible Multibody System with Elastic Impact

THEORETICAL ANALYSIS OF THE THREE BALLS SYSTEM WITH MULTIPLE IMPACT

Numerical and experimental studies on impact dynamics of a planar flexible multibody system

Design of a low-velocity impact framework for evaluating space-grade materials

Experimental study on the elastic response characteristics of a rotating body under an oblique water impact load

Mathematical modeling of linear viscoelastic impact: Application to drop impact testing of articular cartilage

Global Impact Dynamic Modeling and Verification of A Flexible Beam with Large Overall Motion

Elastoplastic impact of a long rod on a flexible large plate

Measurement of large deformation of material under impact tensile loading

Assessment of Multilayered Plates with Hyperelastic Coatings Subjected to Dynamic Loadings by Impact at Low Velocities

DROP IMPACT ONTO A CANTILEVER BEAM: BEHAVIOR OF THE LAMELLA AND FORCE MEASUREMENT

The Experiment of In-Plane Impact Based on a Two-Dimensional High Speed Camera System

The Analysis of Longitudinal Impact Response for Variable Cross-Section Rod

Numerical and Experimental Investigations on a Three-Dimensional Rod-Plate Impact

DYNAMIC EXPERIMENTAL INVESTIGATION OF AN UNILATERAL IMPACTING CANTILEVER BEAM