Abstract:Measurements made on the interstitial microwave antennas used for hyperthermia cancer therapy indicate that the heating patterns vary with the insertion depths (defined as the distance from the antenna tip to air-tissue interface). The antennas are made of thin coaxial cables with a radiation gap or gaps on the outer conductor. The antennas are inserted into small polypropylene catheters implanted in the tumour volume. This type of antenna may be simulated as an asymmetric dipole with one arm being the tip section consisting of the expanded extension of the inner conductor, and the other arm being the section of the outer conductor from the gap to the insertion point (air-tissue interface). We use four of the antennas to form a 2 cm x 2 cm array. The antennas are positioned on the corners of a 2 cm square. Measurements on both single antennas and multi-antenna arrays show that the maximum heating is not stationary with position along the antenna when the depth of insertion is changed. This paper investigates the theoretical prediction of the changes in heating patterns of interstitial microwave antennas at different insertion depths. Each of the antennas in the array is simulated as an asymmetric dipole. The SAR (specific absorption rate) is computed by using the insulated dipole theory. The temperature distribution in absence of perfusion is obtained through a thermal simulation routine to convert the SAR pattern into the temperature pattern. Excellent qualitative agreement is found between the theoretical heating pattern and the measured pattern in a non-perfused phantom on a 2 cm x 2 antenna array. Since the insertion depths of the interstitial antennas are different from patient to patient, it is recommended that simulation of the heating be done before treatments, to confirm the delivery of power to the target region.

Analysis of the power coupling from a waveguide hyperthermia applicator into a three-layered tissue model

The Penetrated and Scattered Field Distributions in the Presence of A Nonuniform Cold Magnetized Plasma Column Surrounded by Multiple Apertures: Te-Wave Incidence

The near-zone field characteristics of an E-polarization plane wave penetrating through cylindrical multiple apertures (non) coated with lossy and lossless media

Multiple Penetration of a E-Polarization Plane Wave through Multiple Cylindrical Apertures

Multiple penetration of a TE/sub z/-polarized plane wave into multilayered cylindrical cavity-backed apertures

A Modal Analysis of Electromagnetic Fields Coupling into an Open-Ended Waveguide Mounted on a Finite Flange: Evaluation of a Rectangular Waveguide with a Square Flange

Analysis of Radiation Characteristics of Conformal Microstrip Arrays Using Adaptive Integral Method

Hybrid of Scattering Matrix Method and Integral Equation Used for Co-simulation of Power Integrity and EMI in Electronic Package with Large Number of P/G Vias

Development of metasurface based hyperthermia lens applicator for heating of cancerous tissues

Tissue Temperature Distributions for Different Frequencies derived from Interstitial Microwave Hyperthermia

The Effect of Interface Resistances on Thermal Wave Propagation in Multi-Layered Samples

Numerical Analysis of Local Non-Equilibrium Heat Transfer in Layered Spherical Tissue During Magnetic Hyperthermia.

Multiphysics Analysis of Ka-band U-shaped Microstrip Line Planar Traveling Wave Tube

Investigation of Terahertz Wave Propagation along Parallel-Plate Dielectric Waveguide Using Various Metal Conductivity Models

Temperature Distribution of Human Tissue in Interstitial Microwave Hyperthermia

Power Deduction from Surface Fields in Multilayer Waveguides

Analytical Modeling of a Two-Dimensional Waveguide-Fed Metasurface

Heat transfer analysis for tissue with surface heat flux based on the non-linearized form of the three-phase-lag model

Prediction of heating patterns of a microwave interstitial antenna array at various insertion depths

Passage of an electromagnetic wave through a rectangular waveguide with a section of a semiconductor film

Electromagnetic–thermal field coupling in tissue ablation: The EAES design and optimization