Abstract:With the continued device scaling and the introduction of new device structures, MOSFET reliability phenomena arising from the hot carrier injection (HCI) stress have received extensive attention from both the academia and the industry community. In this work, the degradations of ultra-scaled silicon on insulator (SOI) MOSFETs under the HCI stress are investigated on devices of different gate lengths (L=30-150 nm). Our experimental data demonstrate that the time evolutions of the threshold voltage change (Vth) under the HCI stress for different gate length devices are the same, and the magnitude of Vth reduces for the shorter devices. The degradation of the device under the HCI stress should be due to both the channel hot carrier (CHC) effect and the bias temperature instability (BTI) effect. The distribution and magnitude of the electric field along the MOSFET's channel are analyzed. It is confirmed that besides the well-known CHC effect in the depletion region close to the drain side, a strong BTI effect co-exists in the channel close to the source side. This degradation mechanism is different from the conventional HCI stress. With the gate length decreasing, the contribution of the aforementioned BTI effect becomes larger, and it dominates in the degradation. One feature of the BTI effects is that the corresponding degradation is small when the gate length is short. This is consistent with our experimental result that the change of Vth is small for the device of short gate length under the accelerated HCI stress. The time evolution of Vth can be described by the equation Vth=A•tn, where A is a constant, t is the stress time, and n is the power law exponent obtained by the curve fitting. In this study, the power law exponent n of pMOSFET is larger than that of nMOSFET. This experimental fact can lead to the point that the BTI effect exists during the HCI stress because the BTI effect in ultra-scaled pMOSFETs is more significant than that in nMOSFETs. The stress-recover experiments of the HCI stress on MOSFTTs show larger recovery in device of shorter gate length. It is found that the ratio of the recovery to the total degradation in the 30 nm gate-length device is almost twice as large as that in the 150 nm device. The degradation from the CHC effect has no recovery, and the larger recovery in the shorter-channel device implies the larger component of the BTI degradation. Another intriguing fact is that our experimental result on SOI MOSFET is inconsistent with the recently reported result on FinFET. We argue that the reported stronger HCI degradation in FinFET may not be ascribed only to the stronger electric field in the shorter channel, but also to the fact that the FinFET' channel is three-dimensionally surrounded by the gate dielectric. This kind of three-dimensional structure significantly increases the chance for electrons or holes to be injected into the dielectric layer. Therefore the HCI reliability of planar SOI MOSFETs may be better than that of FinFETs at the same level of gate length. In conclusion, the BTI effect is an important source of the degradation during the HCI stress in ultra-short-channel device, and it is no more negligible in analyzing the underlying physical mechanism.

Simulating the competing effects of P- and N-MOSFET hot-carrier aging in CMOS circuits

A Reliability Model for CMOS Circuit Based on Device Degradation

Advanced 45nm MOSFET small-signal equivalent circuit aging under DC and RF hot carrier stress

Compact reliability model for degradation of advanced p-MOSFETs due to NBTI and hot-carrier effects in the circuit simulation

A physical based model to predict performance degradation of FinFET accounting for interface state distribution effect due to hot carrier injection

Gate Length Dependence of Hot Carrier Injection Degradation in Short Channel Silicon on Insulator Planar Mosfet

Comparative Investigation on Aging Precursor and Failure Mechanism of Commercial SiC MOSFETs Under Different Power Cycling Conduction Modes

Modeling of Degradation Caused by Channel Hot Carrier and Negative Bias Temperature Instability Effects in P-Mosfets

Parameter correlation and modeling of the power-law relationship in MOSFET hot-carrier degradation

Physical Principles of Self-Consistent Simulation of the Generation of Interface States and the Transport of Hot Charge Carriers in Field-Effect Transistors Based on Metal–Oxide–Semiconductor Structures

Modeling of PMOS NBTI Effect Considering Temperature Variation

Competitive Failures Decoupling and Mechanisms Analysis of SiC MOSFET Module Under Power Cycling Stress

A Device-Circuit Aging Simulation Framework Integrating Trap-Based Models and Sensitivity Analysis for FinFET Technology

Hot Carrier Induced Degradation in Mesa-Isolated N-Channel SOI MOSFETs Operating in a Bi-MOS Mode

Investigation of the Off-State Degradation in Advanced FinFET Technology—Part II: Compact Aging Model and Impact on Circuits

The Understanding and Compact Modeling of Reliability in Modern Metal–Oxide–Semiconductor Field-Effect Transistors: From Single-Mode to Mixed-Mode Mechanisms

An equivalent circuit model of HCI effect for short-channel N-MOSFET

Transient Self-Heating Effects on Mixed-Mode Hot Carrier and Bias Temperature Instability in FinFETs: Experiments and Modeling

System-level variation-aware aging simulator using a unified novel gate-delay model for bias temperature instability, hot carrier injection, and gate oxide breakdown

Degradation Of 4h-Sic Mosfets Under Different Short Circuit Test Conditions: A Simulation Study

Towards Reliability-Aware Circuit Design in Nanoscale FinFET Technology: — New-generation Aging Model and Circuit Reliability Simulator