Abstract:Solar cells have attracted much attention since they can convert solar energy directly into electricity, and have been widely utilized in manufacturing industry and people's daily life. Although the power conversion efficiency (PCE) of single-junction solar cells has gradually improved in recent years, its maximum efficiency is restricted by the Shockley-Queisser (SQ) limit of single-junction solar cells. To exceed the SQ limit and further obtain high efficiency solar cells, researchers have proposed the concept of tandem solar cells. In this work, a systematic theoretical study of chalcopyrite CuGaSe 2 /CuInSe 2 tandem solar cells was carried out by combining first-principle calculations and SCAPS-1D device simulations. Firstly, the electronic structure, defect properties and corresponding macroscopic performance parameters of CuGaSe 2 (CGS) were obtained by first-principles calculations, which were adopted as input parameters for subsequent device simulations of CGS solar cells. Subsequently, the simulations of single-junction CGS and CuInSe 2 (CIS) solar cells were carried out using SCAPS-1D software, respectively. The simulation results for the single junction CIS solar cells are in good agreement with the experimental values. For single-junction CGS cells, the device simulations revealed that CGS single-junction solar cells had the highest short-circuit current (J sc ) and PCE at the growth condition of Cu-rich, Ga-rich and Se-poor chemical growth condition. Further optimization found that the open-circuit voltage (V oc ) and PCE of CGS solar cells can be improved by replacing the electron transport layer (ETL) with ZnSe after the devices with the highest short-circuit current (J sc ). Finally, after the optimized CGS and CIS solar cells were connected in series with two-terminal (2T) monolithic tandem solar cell, the device simulation results show that under the growth temperature of 700 K and the growth environment of Cu-rich, Ga-rich, and Se-poor, with ZnSe as the ETL, the CGS thickness of 2000 nm and the CIS thickness of 1336 nm, the PCE of 2T monolithic CGS/CIS tandem solar cell can reach 28.91 %, which is higher than the recorded efficiency of the current single-junction solar cells, and shows a good application prospect.

Suitable Top Cell Partners for Copper Indium Gallium Selenide‐Based Tandem Solar Cells to Achieve >30% Efficiency

Perovskite/Colloidal Quantum Dot Tandem Solar Cells: Theoretical Modeling and Monolithic Structure

Perovskite-CIGS Monolithic Tandem Solar Cells with 29.7% Efficiency: A Numerical Study

Toward high-efficiency solution-processed tandem solar cells

Over 28% Efficiency Perovskite/Cu(InGa)Se2 Tandem Solar Cells: Highly Efficient Sub-cells and Their Bandgap Matching

RbGeI3/CuZnSnSSe/CuInGaSe/CdS tandem solar cell with improved performance and lowered cost

Design and performance investigation of CIGS/SWCNT tandem solar cell for efficiency improvement

Top cell design and optimization of all-chalcopyrite CuGaSe 2 /CuInSe 2 two-terminal tandem solar cells: first-principles calculations and device simulations

Investigation on Preparation and Performance of High Ga CIGS Absorbers and Their Solar Cells.

Simulations of Chalcopyrite/c-Si Tandem Cells Using SCAPS-1D

Electrical and Optical Investigation of 2T–Perovskite/u-CIGS Tandem Solar Cells With ~30% Efficiency

Fabrication and Optimization of CdSe Solar Cells for Possible Top Cell of Silicon‐Based Tandem Devices

Simulating High‐Efficiency, Lead‐Free Inorganic‐Organic Perovskite Tandem Solar Cells with over 46% Efficiency

Proposal and Design of Organic/CIGS Tandem Solar Cell: Unveiling Optoelectronic Approaches for Enhanced Photovoltaic Performance

High-Performance Perovskite/Cu(In,Ga)Se-2 Monolithic Tandem Solar Cells

Combined Optical-Electrical Optimization of Cd1-xZnxTe/Silicon Tandem Solar Cells

Study on the Thickness Effect of Wide-Bandgap CuGaSe2 Thin Films for Applications with Tandem Solar Cells

Highly efficient Ag-alloyed Cu(In,Ga)Se2 solar cells with wide bandgaps and their application to chalcopyrite-based tandem solar cells

Bilayer CIGS-based solar cell device for enhanced performance: a numerical approach

Comprehensive Design and Analysis of Thin Film Sb2S3/CIGS Tandem Solar Cell: TCAD Simulation Approach

Design and optimization of CdSe-CuSbSe2-based double-junction two-terminal tandem solar cells with VOC> 2.0 V and PCE over 42%