Abstract:Novel chitosan (CS) composite membranes modified with ionic liquids (ILs), namely, 1-Hexyl-3- methylimidazolium tricyanomethanide ([HMIM][TCM]), Diethylmethylammonium methanesulfonate ([DEMA][OMs]), were synthesized to be used as a polymer electrolyte membrane (PEM) in for PEM fuel cells. The ionic conductivities of the prepared membrane samples were evaluated using electrochemical impedance spectroscopy (EIS). The CS is one of the attractive choices of green and sustainable membrane materials in PEMs because of its chemical tunability and cost-effectiveness. The membranes were prepared by solution casting followed by a solvent evaporating procedure. The low proton conductivity of pristine CS biopolymer was enhanced by the incorporation of ILs in the membrane framework. Tensile testing confirmed the excellent membrane mechanical integrity. A significant enhancement in the membranes' characteristics was observed upon the introduction of [DEMA][OMs] into its matrix. The experimental results showed enhanced proton conductivities of the prepared membranes along with enhanced flexibility. The proton conductivity of pristine CS membrane was increased from 8.4 × 10 −4 to 1.25 × 10 −2 S/cm and 1.1 × 10 −2 S/cm when a 30 wt% [HMIM][TCM] and 100 wt% [DEMA][OMs] were added, respectively. Synergistic effects of amine and imidazolium-based ILs on the electrical, structural, water uptake, and thermal properties of CS-based biopolymer solid electrolyte membranes are reported for the first time in this work. The aforementioned characterization results demonstrate the potential of using these membranes in PEM fuel cells operating above the boiling point of water and at a lower cost. This work showed that there should be an optimization amount of the ILs content in the membrane to maintain its mechanical integrity.

A Review on Ionic Liquids-Based Membranes for Middle and High Temperature Polymer Electrolyte Membrane Fuel Cells (PEM FCs)

A Critical Review on the Use of Ionic Liquids in Proton Exchange Membrane Fuel Cells

Enhancing Polymer Electrolyte Membrane Fuel Cells with Ionic Liquids: A Review

Development of proton-exchange membrane fuel cell with ionic liquid technology

Polybenzimidazole/ionic-liquid-functional Silica Composite Membranes with Improved Proton Conductivity for High Temperature Proton Exchange Membrane Fuel Cells

Ionic Liquid in Phosphoric Acid-Doped Polybenzimidazole (PA-PBI) as Electrolyte Membranes for PEM Fuel Cells: A Review

Composite Membranes Based on Polybenzimidazole and Ionic Liquid Functional Si–O–Si Network for HT-PEMFC Applications

Novel Cross-Linked Membranes Based on Polybenzimidazole and Polymeric Ionic Liquid with Improved Proton Conductivity for HT-PEMFC Applications

Ionic liquid‐modified materials as polymer electrolyte membrane and electrocatalyst in fuel cell application: An update

Advances in ionogels for proton-exchange membranes

Advancements in proton exchange membranes for high-performance high-temperature proton exchange membrane fuel cells (HT-PEMFC)

Solid polymer electrolyte membranes for fuel cell applications—a review

Sulfonated poly(ether ether ketone)-Protic ionic Liquid-Based anhydrous Proton-Conducting composite polymer electrolyte membranes for High-Temperature fuel cell applications

Novel chitosan-ionic liquid immobilized membranes for PEM fuel cells operating above the boiling point of water

Perspectives on Membrane Development for High Temperature Proton Exchange Membrane Fuel Cells

Advances in Ion Conducting Membranes and Binders for High Temperature Polymer Electrolyte Membrane Fuel Cells

Impact of cation selection on proton exchange membrane fuel cell performance with trimethylethyl amide, ethylpyridinium and ethylmethyl imidazolium ionic liquid carried by poly(vinylidene fluoride) membrane as electrolyte

Design of sepiolite-supported ionogel-embedded composite membranes without proton carrier wastage for wide-temperature-range operation of proton exchange membrane fuel cells

Impact of a protic dimeric ionic liquid on PEM fuel cell performance and durability

Recent Advances in Ionic Liquids—MOF Hybrid Electrolytes for Solid-State Electrolyte of Lithium Battery

A Review of Recent Developments and Advanced Applications of High-Temperature Polymer Electrolyte Membranes for PEM Fuel Cells