Experimental study of methanol atomization and spray explosion characteristic under negative pressure
Feng Wu,Hao Yu,Xuhai Pan,Xiaowei Zang,Min Hua,He Wang,Juncheng Jiang
DOI: https://doi.org/10.1016/j.psep.2022.03.029
IF: 7.8
2022-05-01
Process Safety and Environmental Protection
Abstract:Leakage of methanol under negative pressure may cause high dangerous spray explosion in the process industry. The explosion characteristics of methanol spray under the combined effects of multi-factor have not yet been studied. Hence, combined effects of spray concentration (198.0–514.8 g/m3), ambient temperature (298.15–323.15 K) and injection pressure (13–21 bar) on atomization and spray explosion of methanol (308.15 K) in 20 L spherical vessel under negative pressure (0.80–1.00 bar) were studied in this paper. The results showed that the decrease of methanol concentration, the increase of ambient temperature and injection pressure all promoted the breakage of methanol spray with linear trend. Based on the negative pressure, the effect weights of concentration, ambient temperature, and injection pressure were 113.7 µm/bara, 243.3 µm/bara, 64.24 µm/bara, respectively. The "peak plateau" of explosion temperature lasted for 237.6 ms due to the multi-point source ignition. In contrast to the explosion pressure change, the temperature of methanol spray slightly decreased in delayed ignition region. The increase of spray concentration provided more combustibles and contributed to the spray explosion when the methanol concentration was below 356.4 g/m3. As the concentration continued to rise, the maximum explosion pressure under room pressure (0.1 bar) decreased inhibited by the poor oxygen, while the maximum explosion pressure under negative pressure (0.80–0.95 bar) slowly increased. The increase of ambient temperature promoted the maximum explosion pressure, temperature and the rate of pressure rise, especially the promotion under negative pressure, was more significant. The variation of the maximum explosion pressure and maximum rate of pressure rise was consistent with that of the spray particle size when influenced by injection pressure. The experimental results showed that the methanol spray was more explosive and dangerous under negative pressure.The mean local reaction rate related to the average expansion across the front and computed from the mean velocity divergence is evaluated in this work. Measurements are carried out in a air/methane premixed jet flame by combined PIV/LIF acquisitions. The procedure serves the purpose of obtaining values of a turbulent flame speed, namely the local turbulent consumption speed SLC, as a function of the position along the bunsen flame. With the further position that the flamelet assumption provides a proportionality between turbulent burning speed normalized with the laminar unstretched one and the turbulent to average flame surface ratio, the proportionality constant, i.e., the stretching factor becomes available. The results achieved so far show the existence of a wide region along which the bunsen flame front has a constant stretching factor which apparently depends only on the ratio between turbulent fluctuations and laminar flame speed and on the jet Reynolds number.Herein, a series of experiments were performed to illustrate the impact of safety vents on the evolution of thermal runaway behaviors of 18650-size lithium-ion batteries. Meanwhile, the effect of safety vents on the thermal safety of batteries with different states of charge (SOC), i.e. 0%, 50% and 100% and cathode chemistries, i.e. lithium nickel manganese cobalt oxide (NMC), lithium cobalt oxide (LCO) and lithium iron phosphate (LFP) was explored. Compared with the battery with a safety vent, the thermal runaway behaviors of the battery in the absence of a safety vent are greatly worsened with ignition and thermal runaway occurring far earlier. As the battery SOC increases, it is demonstrated that the effect of the safety vent on battery thermal safety is reduced to some extent, with the difference in the times to thermal runaway between the batteries with and without a safety vent decreasing gradually. Besides that, it is found that the effect of the safety vent on the thermal runaway features of LFP-based batteries is relatively minor than in NMC-based batteries and LCO-based batteries. There is a linear-increasing relationship between the thermal runaway time difference and the mass loss difference for batteries with and without a safety vent.Owing to the inherent complications in membrane distillation (MD) operations, it has become a challenge to acknowledge swiftly and appropriately to safeguard the quality of effluent, particularly when the processing cost is a prominent concern. Membrane wetting in MD operations is a major concern during long-term performance. In this study, machine learning (ML) methodologies were utilized to overcome the limitations of conventional mechanistic modeling. ML applications have never been explored to investigate how operatio -Abstract Truncated-
engineering, environmental, chemical