Abstract:Abstract. Wind data collection in the atmospheric boundary layer benefits from short-term wind speed measurements using unmanned aerial vehicles. Fixed-wing and rotary-wing devices with diverse anemometer technology have been used in the past to provide such data, but the accuracy still has the potential to be increased. A lightweight drone for carrying an industry-standard precision sonic anemometer was developed. Accuracy tests have been performed with the isolated anemometer at high tilt angles in a calibration wind tunnel, with the drone flying in a large wind tunnel and with the full system flying at different heights next to a bistatic lidar reference. The propeller-induced flow deflects the air to some extent, but this effect is compensated effectively. The data fusion shows a substantial reduction of crosstalk (factor of 13) between ground speed and wind speed. When compared with the bistatic lidar in very turbulent conditions, with a 10 s averaging interval and with the unmanned aerial vehicle (UAV) constantly circling around the measurement volume of the lidar reference, wind speed measurements have a bias between −2.0 % and 4.2 % (root-mean-square error (RMSE) of 4.3 % to 15.5 %), vertical wind speed bias is between −0.05 and 0.07 m s−1 (RMSE of 0.15 to 0.4 m s−1), elevation bias is between −1 and 0.7∘ (RMSE of 1.2 to 6.3∘), and azimuth bias is between −2.6 and 7.2∘ (RMSE of 2.6 to 8.0∘). Key requirements for good accuracy under challenging and dynamic conditions are the use of a full-size sonic anemometer, a large distance between anemometer and propellers, and a suitable algorithm for reducing the effect of propeller-induced flow. The system was finally flown in the wake of a wind turbine, successfully measuring the spatial velocity deficit and downwash distribution during forward flight, yielding results that are in very close agreement to lidar measurements and the theoretical distribution. We believe that the results presented in this paper can provide important information for designing flying systems for precise air speed measurements either for short duration at multiple locations (battery powered) or for long duration at a single location (power supplied via cable). UAVs that are able to accurately measure three-dimensional wind might be used as a cost-effective and flexible addition to measurement masts and lidar scans.

A Preliminary Investigation of Low-Cost SODAR Anemometry

Wind Speed Measurement by an Inexpensive and Lightweight Thermal Anemometer on a Small UAV

Field Measurement System Based on a Wireless Sensor Network for the Wind Load on Spatial Structures: Design, Experimental, and Field Validation

Low-Altitude Wind Measurement Using Incoherent Doppler Lidar by Utilizing Both Absorption Slopes of the Iodine Absorption Spectrum

Coastal Wind Measurements Using a Single Scanning LiDAR

Multilevel Validation of Doppler Wind Lidar by the 325 m Meteorological Tower in the Planetary Boundary Layer of Beijing

A Study on Measuring the Wind Field in the Air Using a Multi-rotor UAV Mounted with an Anemometer

Low-altitude atmospheric wind measurement from the combined Mie and Rayleigh backscattering by Doppler lidar with an iodine filter

Novel Rotor Effective Wind Speed Estimation Method for Light Detection and Ranging Application

Development of Direct-Detection Doppler Wind Lidar for Vertical Atmospheric Motion

Validation of Doppler Wind LiDAR measurements with an Uncrewed Aerial System (UAS) in the daytime atmospheric boundary layer

Near-Surface Wind Profiling in a Utility-Scale Onshore Wind Farm Using Scanning Doppler Lidar: Quality Control and Validation

Towards accurate and practical drone-based wind measurements with an ultrasonic anemometer

Incoherent Doppler Lidar System Using Differential Discrimination Technique for Tropospheric Wind Measurement

Research on optimizing the optical local-oscillator power of Coherent Doppler LiDAR to enhance wind velocity measurements

Uncertainties in temperature statistics and fluxes determined by sonic anemometer due to wind-induced vibrations of mounting arms

Wind field reconstruction from nacelle-mounted lidar short-range measurements

Design and demonstration of a sensing network for full-scale wind pressure measurements on buildings

Evaluation of Probe-Induced Flow Distortion of Campbell CSAT3 Sonic Anemometers by Numerical Simulation

Wind resource assessment on complex terrain based on observations of a single anemometer