Abstract:<p>One of the essential characteristics of electronically controlled air suspension (ECAS) is that the automotive height is adjustable. Because ECAS system has complex nonlinearity and noticeable hysteresis, it is easy to make the vehicle oscillate near the target height due to the overcharge/discharge of air springs, which would cause the instability of vehicle body posture. More than that, the existence of external disturbances and uneven loads has impacts on body height control. The complex nonlinear characteristics and the existence of external interference put forward higher requirements for the design of ECAS body height controller. In this paper, by non-singular coordinate transformation, the nonlinear model of the 1/4 ECAS body height regulation system is transformed into a linear model with a third-order integral chain firstly, which is closer to the real dynamic characteristics of the suspension system than the linear system with low order. Secondly, based on continuous finite-time theory, a continuous finite-time feedback stabilization controller with small parameters is designed, and it turned out that the height regulation system can achieve finite-time stability. Finally, the simulation results under sinusoidal and random disturbances show that with the comparison with the traditional PD control, the designed finite-time controller can not only guarantee the system faster response speed and better control accuracy but also obtain the better anti-jamming performance. By innovatively applying the finite-time theory to the ECAS system, the designed control system in this paper can afford good robustness for ECAS height adjustment and has great significance to improve the overall performance of ECAS system.</p>

Adaptive ride height controller design for vehicle active suspension systems with uncertain sprung mass and time‐varying disturbance

Robust Adaptive Control of an Automotive Active Air Suspension System with Input Delay

Neural Network-Based Adaptive Height Tracking Control of Active Air Suspension System with Magnetorheological Fluid Damper Subject to Uncertain Mass and Input Delay

Integrated Model Predictive Control and Adaptive Unscented Kalman Filter for Semi-Active Suspension System Based on Road Classification

Adaptive Tracking Control for Active Suspension Systems with Non-Ideal Actuators

Neuroadaptive Control for Active Suspension Systems With Time-Varying Motion Constraints: A Feasibility-Condition-Free Method

Body height robust control of automotive air suspension system using finite‐time approach

Actuator Failure Compensation-Based Adaptive Control of Active Suspension Systems With Prescribed Performance

Constrained Robust Adaptive Control for Vehicle Active Suspension Systems

Adaptive Backstepping Control for Active Suspension Systems with Hard Constraints

A New Model-Free Adaptive Sliding Controller for Active Suspension System.

Hybrid model predictive control on lifting and dropping vehicle body via asymmetric damping adjustment

Robust control design for active suspension system with uncertain dynamics and actuator time delay

Adaptive Sliding Controller with Self-Tuning Fuzzy Compensation for Vehicle Suspension Control

Robust finite-time fault-tolerant control for vehicle height and posture regulation with air suspension system subject to actuator faults, uncertainties and external disturbance

Adaptive Sensor Fault Accommodation for Vehicle Active Suspensions Via Partial Measurement Information

Functional Based Adaptive and Fuzzy Sliding Controller for Non-Autonomous Active Suspension System

Multi-objective H2/H∞ control of uncertain active suspension systems with interval time-varying delay

Adaptive Event-Triggered Control for Vehicle Active Suspension Systems with State Constraints

Reliability control for uncertain half-car active suspension systems with possible actuator faults

Multi-objective frequency domain-constrained static output feedback control for delayed active suspension systems with wheelbase preview information