Orthogonal Design Process Optimization for Particle Charge Distribution of Mosquito Coil Smoke Aerosol Enhanced by Pulsed Corona Discharge
Jian-Ping Jiang,Zhong-Yang Luo,Hao Chen,Dong Zhou,Dong-Hui Sha,Meng-Xiang Fang,Ke-Fa Cen
DOI: https://doi.org/10.1016/j.powtec.2015.08.029
IF: 5.64
2015-01-01
Powder Technology
Abstract:Pulsed corona discharge (PCD) is one of the most commonly used methods for particle charging. In this study, a mosquito coil smoke aerosol with a diameter smaller than 0.5μm was used to investigate the charging of fine particles using an electrical low-pressure impactor (ELPI). The average number of charges per particle increases as the particle diameter becomes larger. Orthogonal design and single-factor analysis were carried out to optimize the particle charging conditions. The factors range as follows: wire–wire distance, dww=single one wire and three wires with a distance of 3–9cm; wire–plate distance, dwp=3–6cm; impulse-peak voltage, V=30–45kV; and impulse frequency, ƒ=100–300Hz. The results show that dww is the dominant factor, and the optimal conditions are as follows: a) for diameter smaller than 0.04μm: dwp=5cm, dww=9cm, V=35kV, and ƒ=300Hz; b) for the size range of 0.04–0.2μm: dwp=4cm, dww=9cm, V=45kV, and ƒ=300Hz; c) for the size range of 0.2–0.48μm: dwp=4cm, dww=9cm, V=45kV, and ƒ=100Hz. Moreover, the particle charging is much more difficult for the particle with a diameter of 0.2μm than the others.