Abstract:Polymerase chain reaction (PCR) is the most common method used for nucleic acid (DNA) amplification. The development of PCR-performing microfluidic reactors (μPCRs) has been of major importance, due to their crucial role in pathogen detection applications in medical diagnostics. Closed loop (CL) is an advantageous type of μPCR, which uses a circular microchannel, thus allowing the DNA sample to pass consecutively through the different temperature zones, in order to accomplish a PCR cycle. CL μPCR offers the main advantages of the traditional continuous-flow μPCR, eliminating at the same time most of the disadvantages associated with the long serpentine microchannel. In this work, the performance of three different CL μPCRs designed for fabrication on a printed circuit board (PCB) was evaluated by a computational study in terms of the residence time in each thermal zone. A 3D heat transfer model was used to calculate the temperature distribution in the microreactor, and the residence times were extracted by this distribution. The results of the computational study suggest that for the best-performing microreactor design, a PCR of 30 cycles can be achieved in less than 3 min. Subsequently, a PCB chip was fabricated based on the design that performed best in the computational study. PCB constitutes a great substrate as it allows for integrated microheaters inside the chip, permitting at the same time low-cost, reliable, reproducible, and mass-amenable fabrication. The fabricated chip, which, at the time of this writing, is the first CL μPCR chip fabricated on a PCB, was tested by measuring the temperatures on its surface with a thermal camera. These results were then compared with the ones of the computational study, in order to evaluate the reliability of the latter. The comparison of the calculated temperatures with the measured values verifies the accuracy of the developed model of the microreactor. As a result of that, a total power consumption of 1.521 W was experimentally measured, only ~7.3% larger than the one calculated (1.417 W). Full validation of the realized CL μPCR chip will be demonstrated in future work.

A power-efficient thermocycler based on induction heating for DNA amplification by polymerase chain reaction

FEA for Steady-State Thermal Performance of PCR Thermal-Cycler Based on Thermoelectric Cooler

A Thermal Cycler Based on Magnetic Induction Heating and Anti-Freezing Water Cooling for Rapid PCR

A Rapid and Low-Cost PCR Thermal Cycler for Low Resource Settings

A Thermocycler Using a Chip Resistor Heater and a Glass Microchip for a Portable and Rapid Microchip-Based PCR Device

Ultrafast Microfluidic PCR Thermocycler for Nucleic Acid Amplification

Implementation of Rapid Nucleic Acid Amplification Based on the Super Large Thermoelectric Cooler Rapid Temperature Rise and Fall Heating Module

Fabrication of an Oscillating Thermocycler to Analyze the Canine Distemper Virus by Utilizing Reverse Transcription Polymerase Chain Reaction

Portable and Battery-Powered PCR Device for DNA Amplification and Fluorescence Detection

One-PCR-tube approach for in situ DNA isolation and detection.

The Polymerase Chain Reaction: DNA Extraction and Amplification

High-throughput PCR in silicon based microchamber array

A Thermal Cycler based on Solid-state Active Heat Pump and PID Control Algorithm toward Biomedical Applications

A Microchip-Based PCR Device Using Flexible Printed Circuit Technology

Progress in molecular detection with high-speed nucleic acids thermocyclers

Biochemically Programmable Isothermal PCR

Closed-Loop Microreactor on PCB for Ultra-Fast DNA Amplification: Design and Thermal Validation

Lead-start isothermal polymerase amplification controlled by DNAzymatic switches.

Self-primed Isothermal Amplification for Genomic DNA Detection of Human Papillomavirus.

Customizable Nichrome Wire Heaters for Molecular Diagnostic Applications

High-throughput SNP genotyping by single-tube PCR with Tm-shift primers.