Abstract:The results of molecular dynamics (MD) simulations of the crystallization process in one-component materials and solid solution alloys reveal a complex temperature dependence of the velocity of the crystal-liquid interface featuring an increase up to a maximum at 10-30% undercooling below the equilibrium melting temperature followed by a gradual decrease of the velocity at deeper levels of undercooling. At the qualitative level, such non-monotonous behaviour of the crystallization front velocity is consistent with the diffusion-controlled crystallization process described by the Wilson-Frenkel model, where the almost linear increase of the interface velocity in the vicinity of melting temperature is defined by the growth of the thermodynamic driving force for the phase transformation, while the decrease in atomic mobility with further increase of the undercooling drives the velocity through the maximum and into a gradual decrease at lower temperatures. At the quantitative level, however, the diffusional model fails to describe the results of MD simulations in the whole range of temperatures with a single set of parameters for some of the model materials. The limited ability of the existing theoretical models to adequately describe the MD results is illustrated in the present work for two materials, chromium and silicon. It is also demonstrated that the MD results can be well described by the solution following from the hodograph equation, previously found from the kinetic phase-field model (kinetic PFM) in the sharp interface limit. The ability of the hodograph equation to describe the predictions of MD simulation in the whole range of temperatures is related to the introduction of slow (phase field) and fast (gradient flow) variables into the original kinetic PFM from which the hodograph equation is obtained. The slow phase-field variable is responsible for the description of data at small undercoolings and the fast gradient flow variable accounts for local non-equilibrium effects at high undercoolings. The introduction of these two types of variables makes the solution of the hodograph equation sufficiently flexible for a reliable description of all nonlinearities of the kinetic curves predicted in MD simulations of Cr and Si. This article is part of the theme issue 'Transport phenomena in complex systems (part 1)'.

Kinetic Monte Carlo simulation of formation of microstructures in liquid droplets

Monte Carlo simulation of colloidal particles dynamics in a drying drop

Molecular dynamics simulations of the evaporation of particle-laden droplets

Monte-Carlo simulation of grain growth in Vapor-Liquid-Solid phase sintered material

An Enhanced Phase Field Model for Micron-Scale Droplet Impact with Solidification Microstructure Formation

Kinetic Monte Carlo Simulation of Film Morphologies at the Initial Stages

Monte Carlo computer simulations and electron microscopy of colloidal cluster formation via emulsion droplet evaporation

A Computer Simulation of Nucleation and Growth of Thin Films

Monte Carlo simulation of kinetically slowed down phase separation

A numerical investigation on the influence of liquid properties and interfacial heat transfer during microdroplet deposition onto a glass substrate

Modeling pattern formation in soft flowing crystals

Kinetic Monte Carlo Simulation of Nucleation and Growth Behavior in Surfactant-Mediated Epitaxy

Pattern formation during the evaporation of a colloidal nanoliter drop: a numerical and experimental study

Droplet coalescence by molecular dynamics and phase-field modeling

Surface-dependent scenarios for dissolution-driven motion of growing droplets

Kinetic Monte Carlo Simulation of Thin Film Growth

Microscopic and stochastic simulations of chemically active droplets

Kinetics of solid-liquid interface motion in molecular dynamics and phase-field models: crystallization of chromium and silicon

Kinetic Monte Carlo Simulation Study of the Early Stages of Epitaxial SiC (0001) Growth

Multi-Scale Simulation of Nucleation and Growth of Nanoscale SiC on Si

Monte Carlo Simulation of Particle Coagulation and Sintering