Abstract:This paper presents the first experimental engine and test rig results obtained from a fast response cooled total pressure probe. The first objective of the probe design was to favor continuous immersion of the probe into the engine to obtain a time series of pressure with a high bandwidth and, therefore, statistically representative average fluctuations at the blade passing frequency. The probe is water cooled by a high pressure cooling system and uses a conventional piezoresistive pressure sensor, which yields, therefore, both time-averaged and time-resolved pressures. The initial design target was to gain the capability of performing measurements at the temperature conditions typically found at high pressure turbine exit (800–1100°C) with a bandwidth of at least 40 kHz and in the long term at combustor exit (2000 K or higher). The probe was first traversed at the turbine exit of a Rolls-Royce Viper turbojet engine at exhaust temperatures around 750°C and absolute pressure of 2.1 bars. The probe was able to resolve the high blade passing frequency (≈23 kHz) and several harmonics of up to 100 kHz. Besides the average total pressure distributions rom the radial traverses, phase-locked averages and random unsteadiness are presented. The probe was also used in a virtual three-hole mode yielding unsteady yaw angle, static pressure, and Mach number. The same probe was used for measurements in a Rolls-Royce intermediate pressure burner rig. Traverses were performed inside the flame tube of a kerosene burner at temperatures above 1600°C. The probe successfully measured the total pressure distribution in the flame tube and typical frequencies of combustion instabilities were identified during rumble conditions. The cooling performance of the probe is compared with estimations at the design stage and found to be in good agreement. The frequency response of the probe is compared with cold shock-tube results and a significant increase in the natural frequency of the line-cavity system formed by the conduction cooled screen in front of the miniature pressure sensor were observed.

An Electro‐Optic Pressure Indicator

High Sensitivity Photoelectric Pressure Sensor Based on A Monolithic Dual Photodiode

A novel low‐cost sensor for measuring cylinder pressure and improving performance of an internal combustion engine

Research on On-line Estimation of Engine Indicated Mean Pressure

Characterisation and Validation of an Optical Pressure Sensor for Combustion Monitoring at Low Frequency

An Experimental Study on Engine Dynamics Model Based In-Cylinder Pressure Estimation

Modeling the Influence of Engine Dynamics on Its Indicator Diagram

Vibrating Cantilever Transducer Incorporated in Dual Diaphragms Structure for Sensing Differential Pneumatic Pressure

Influence of the Connecting Passage of a Low Pressure Indicator on Recording

Smart, In Situ, Wide Range Pressure Sensor for Advanced Engine Controls

Unsteady Pressure Measurements With a Fast Response Cooled Probe in High Temperature Gas Turbine Environments

An Electrostatic Comb Excitation Resonant Pressure Sensor for High Pressure Applications

Pressure measurements in detonation engines

A sensitive manometer for rapid chemical reactions

A Differential Hall Effect Based Pressure Sensor

A research on cylinder pressure sensor as an alternative for the camshaft and crankshaft position sensors of engine

A robust flow sensor for high pressure automotive applications

Multiplex in-cylinder pressure measurement utilizing an optical fiber with specific refractive-index composition

Development of indicator diagram measurement system for high speed gasoline engines

Prefabrication design, theoretical framework and simulation demonstration of a meander-shaped MEMS piezoresistive pressure sensor implanted on silicon substrate circular diaphragm for enhancement of key performance parameters utilized for low-pressure applications

High-temperature high-frequency turbine exit flow field measurements in a military engine with a cooled unsteady total pressure probe