Abstract:Calcareous sand has been used as the main filling material in numerous reef constructions. Therefore, understanding its long-term dynamic engineering geological characteristics under cyclic applications of traffic or wave loading is crucial to the design and prediction of the serviceability of reef infrastructures. Considering this, seven monotonic triaxial tests and 33 high-cycle (25,000 cycles) drained triaxial tests were conducted on calcareous sand with various mean effective stresses (p') and cyclic stress ratios (ζ). The results show that the development of the accumulated axial strain (ε1acc) has a strong correlation with the positional relationship between the cyclic stress path and critical strength line (CSL) or static strength envelope (SSE) in the p'-q plane. The critical cyclic stress ratio ζc, that represents the cyclic stress path reaching the CSL, is proposed. When ζ>ζc, the growth rate of ε1acc with ζ increases drastically. Moreover, when the cyclic stress path approaches the SSE, ε1acc enters an incremental collapse state. The increase in p' diminishes the dilatancy of the volumetric strain εv. However, this response of εv reverses from decreasing to increasing with increasing ζ. The resilient modulus (Mr) increases with the number of cycles (N) due to the initial densification. If εv dilation occurs, Mr will decrease with N as particles lose contact. A single parameter for the cyclic stress path ratio (ψ) considering the effects of p', ζ, and SSE is proposed. Additionally, empirical formulas for calculating the ultimate ε1acc and Mr are established. Furthermore, particle degradation significantly worsens ε1acc and εv, but has a more profound effect on the compressibility of εv. This degradation is also detrimental to Mr. A certain deviation trend of the predicted values from the measured values is found to correspond with the relative particle breakage.

Mechanical behaviour of medium-grained sandstones exposed to differential cyclic loading with distinct loading and unloading rates

Energy evolution and macro-micro failure mechanisms of frozen weakly cemented sandstone under uniaxial cyclic loading and unloading

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Undrained Behavior of Sand under Cyclic Paths That Match Storm-Wave Loading Conditions

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Mechanical and microseismic characteristics of sandstones subject to moderate low-frequency differential cyclic loading (DCL) followed by monotonic loading up to failure

Three-dimensional Discrete Element Simulation of the Triaxial Cyclic Loading of Sandstone Based on a Nonlinear Parallel-Bonded Stress Corrosion Model

Study on the mechanical properties of unloading damaged sandstone under cyclic loading and unloading

Effect of Unloading Rate on the Mechanical Behavior and Fracture Characteristics of Sandstones Under Complex Triaxial Stress Conditions

Fluctuation in residual strain and dissipated energy of saturated sandstone under tiered cyclic loading

Mode-I failure and mechanical behavior of sandstone under cyclic loading: Laboratory testing and DEM simulation

Mechanical properties and energy evolution law of water bearing sandstone under cyclic loading

Mechanical Properties and DEM-Based Simulation of Double-Fractured Sandstone under Cyclic Loading and Unloading

Energy Evolution Characteristics of Sandstones During Confining Pressure Cyclic Unloading Conditions

Experimental investigation on the shear mechanical behavior and energy evolution of sandstone subjected to pre-peak cyclic loading

Experimental study of energy dissipation characteristics and crack coalescence modes of cracked sandstone under different cyclic loading paths

Deformation and hysteresis behaviors of sandstone exposed to distinct sequences of variable-frequency compressive cyclic stresses

Undrained Dynamical Behavior of Nanjing Flake-Shaped Fine Sand under Cyclic Loading

Anisotropic Mechanical Behavior of Stratified Sandstone Subjected to Cyclic Loading

Mechanical Behavior and Acoustic Emission Characteristics of Sandstone Under Different Cyclic Loading and Unloading Disturbance Rates

Long-term behaviour and degradation of calcareous sand under cyclic loading