Abstract:Microwaves are a promising source for thermal tumor ablation due to their ability to rapidly heat dispersive biological tissues, often to temperatures in excess of 100 °C. At these high temperatures, tissue dielectric properties change rapidly and, thus, so do the characteristics of energy delivery. Precise knowledge of how tissue dielectric properties change during microwave heating promises to facilitate more accurate simulation of device performance and helps optimize device geometry and energy delivery parameters. In this study, we measured the dielectric properties of liver tissue during high-temperature microwave heating. The resulting data were compiled into either a sigmoidal function of temperature or an integration of the time-temperature curve for both relative permittivity and effective conductivity. Coupled electromagnetic-thermal simulations of heating produced by a single monopole antenna using the new models were then compared to simulations with existing linear and static models, and experimental temperatures in liver tissue. The new sigmoidal temperature-dependent model more accurately predicted experimental temperatures when compared to temperature-time integrated or existing models. The mean percent differences between simulated and experimental temperatures over all times were 4.2% for sigmoidal, 10.1% for temperature-time integration, 27.0% for linear and 32.8% for static models at the antenna input power of 50 W. Correcting for tissue contraction improved agreement for powers up to 75 W. The sigmoidal model also predicted substantial changes in heating pattern due to dehydration. We can conclude from these studies that a sigmoidal model of tissue dielectric properties improves prediction of experimental results. More work is needed to refine and generalize this model.

Numerical modeling and dosimetry of the 35 mm Petri dish under 46 GHz millimeter wave exposure

Numerical dosimetry for cells under millimetre-wave irradiation using Petri dish exposure set-ups

Design and Control of in Vitro Pulse Modulated Microwave Exposure System

A novel dielectric conformal FDTD method for computing SAR distribution of the human body in a metallic cabin illuminated by an intentional electromagnetic pulse (IEMP)

Design and Dosimetric Characterization of a Broadband Exposure Facility for In Vitro Experiments in the Frequency Range 18-40.5 GHz

Study on SAR Distribution of Human Body on the Vehicle Platform Using a Modified FDTD Method

In Vitro Physical and Biological Evaluations of a 2.4 GHz Electromagnetic Exposure Setup

Design and Implementation of a Specialised Millimetre-Wave Exposure System for Investigating the Radiation Effects of 5G and Future Technologies

EMF Exposure Analysis of Combining Specific Absorption Rate and Incident Power Density Using Canonical Dipoles

Investigation of Material Parameters and SAR Distribution in Human Tissue Using FDTD Method

Three-Dimensional FDTD Simulation of Biomaterial Exposure to Electromagnetic Nanopulses

Exposure Assessment for Wearable Patch Antenna Arrays at Millimeter Waves

Signal-Level Models of Pointwise Electromagnetic Exposure for Millimeter Wave Communication

Calculation of Specificabsorption Rate(sar) in Rats Exposed to Electromagnetic Wave Irradiation

Adaptive Temperature Control Applied to a 900-MHz In Vitro Exposure Setup for Nonthermal Effects of a High-Level SAR

Modeling of the Dish Receiver with the Effect of Inhomogeneous Radiation Flux Distribution

Radiofrequency dosimetry for the Ferris-wheel mouse exposure system

Dosimetry of Various Human Bodies Exposed to Microwave Broadband Electromagnetic Pulses

Expanded modeling of temperature-dependent dielectric properties for microwave thermal ablation

Advances in Millimeter-Wave Treatment and Its Biological Effects Development

3-D Numerical Study on the Induced Heating Effects of Embedded Micro/nanoparticles on Human Body Subject to External Medical Electromagnetic Field.