Abstract:The natural convection heat transfer characteristics and mechanism for copper micro-wires in water and air were investigated experimentally and numerically. The wires with diameters of 39.9, 65.8 and 119.1 μm were placed horizontally in water inside of a sealed tube and in air of a large room, respectively. Using Joule heating, the heat transfer coefficients and Nusselt numbers of natural convection for micro-wires in ultra pure water and air were obtained. A three dimensional incompressible numerical model was used to investigate the natural convection, and the prediction with this model was in reasonable accordance with the experimental results. With the decrease of micro-wire diameter, the heat transfer coefficient of natural convection on the surface of micro-wire becomes larger, while the Nu number of natural convection decreases in water and air. Besides, the change rate of Nu number in water decreases apparently with the increase of heat flux and the decrease of wire diameter, which is larger than that in air. The thickness of boundary layer on the wall of micro-wire becomes thinner with the decrease of diameter in both water and air, but the ratio of boundary layer thickness in water to the diameter increases. However, there is almost no change of this ratio for natural convection in air. As a result, the proportion of conduction in total heat transfer of natural convection in water increases, while the convective heat transfer decreases. The velocity distribution, temperature field and the boundary layer in the natural convection were compared with those of tube with conventional dimension. It was found that the boundary layer around the micro-wire is an oval-shaped film on the surface, which was different from that around the conventional tube. This apparently reduces the convection strength in the natural convection, thus the heat transfer presents a conduction characteristic.

Measurement of the Specific Heat at Room Temperature of Copper in the Form of Wire by Electrical Heating

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

Adiabatic Joule Heating of Copper from 4 K to the Melting Temperature

A temperature relaxation method for the measurement of the specific heat of solids at room temperature in student laboratories

Natural Convection Heat Transfer on Surfaces of Copper Micro-Wires

A high-precision method to measure thermal conductivity of solids using reversible heat flux

Use of a Needle Probe to Measure the Thermal Conductivity of Electrically Conductive Liquids at High Temperatures

Short-Hot-Wire Method for the Measurement of the Thermal Conductivity of A Fine Fibre

Thermal Characterization of Micro/nanoscale Conductive and Non-Conductive Wires Based on Optical Heating and Electrical Thermal Sensing

Spectral emissivity of copper and nickel in the mid-infrared range between 250 and 900 $^{\circ}$C

Temperature Measurement on Copper Surfaces for Superconducting Thin Film Cavity Applications

Identification of Temperature-Dependent Thermal Conductivity and Experimental Verification

Simultaneous Measurements of the Thermal Conductivity and Thermal Diffusivity of Molten Salts with a Transient Short-Hot-Wire Method

3 omega method for specific heat and thermal conductivity measurements

Apparatus for the room temperature measurement of low field Nernst and magneto-Seebeck coefficients

Accurate heat capacity determination of solids and liquids using a heat conduction calorimeter

A High-Precision Instrumentation of Measuring Thermal Contact Resistance Using Reversible Heat Flux

A Method for Measuring Thermal Conductivity of Fluids by Using a Small Bead Thermistor.

Thermal Conductivity of Industrial Nb3Sn Wires Fabricated by Various Techniques

A hybrid experimental configuration for emissivity measurement at cryogenic temperatures