Abstract:Focusing on the bending wave characteristic of plate-shell structures, this paper derives the complex band curve of piezoelectric phononic crystal based on the equilibrium differential equation in the plane stress state using COMSOL PDE 6.2. To ascertain the computational model's accuracy, the computed complex band curve is then cross-validated against real band curves obtained through coupling simulations. Utilizing this model, this paper investigates the impact of structural and electrical parameters on the bandgap range and the attenuation coefficient in the bandgap. Results indicate that the larger surface areas of the piezoelectric sheet correspond to lower center bands in the bandgap, while increased thickness widens the attenuation coefficient range with increased peak values. Furthermore, the influence of inductance on the bandgap conforms to the variation law of the electrical LC resonance frequency, and increased resistance widens the attenuation coefficient range albeit with decreased peak values. The incorporation of negative capacitance significantly expands the low-frequency bandgap range. Visualized through vibration transfer simulations, the vibration-damping ability of the piezoelectric phononic crystal is demonstrated. Experimentally, this paper finds that two propagation modes of bending waves (symmetric and anti-symmetric) result in variable voltage amplitudes, and the average vibration of the system decreases by 4-5 dB within the range of 1710-1990 Hz. The comparison between experimental and model-generated data confirms the accuracy of the attenuation coefficient calculation model. This convergence between experimental and computational results emphasizes the validity and usefulness of the proposed model, and this paper provides theoretical support for the application of piezoelectric phononic crystals in the field of plate-shell vibration reduction.

SH wave propagation in a periodic cement-based piezoelectric layered barrier

Bandgap Structures Of Sh-Wave In A One-Dimensional Phononic Crystal With Viscoelastic Interfaces

Theoretical analysis of guided waves propagation in periodic piezoelectric plates with shunting circuits

Control of the Elastic Wave Bandgaps in Two-Dimensional Piezoelectric Periodic Structures

Active tuning of flexural wave in periodic steel-concrete composite beam with shunted cement-based piezoelectric patches

Periodic WIB-trench wave barriers for seismic surface waves

Tunable Bandgaps of Guided Waves by Periodic Shunting Circuits in Multilayered Piezoelectric Plates

A Unified Model for Investigating the Propagation of SH Surface Waves in a Piezoelectric Layered Medium

A novel vibration barrier for low-frequency surface waves in the ground

Effects of Initial Stresses on the Electromechanical Coupling Coefficient of SH Wave Propagation in Multilayered PZT-5H Structures

Theoretical Analysis of Surface Waves in Piezoelectric Medium with Periodic Shunting Circuits

Bandgap characteristics of four component periodic pile barriers in passive vibration isolation

Bandgap Calculation and Experimental Analysis of Piezoelectric Phononic Crystals Based on Partial Differential Equations

Elastic Wave Band Structures and Defect States in A Periodically Corrugated Piezoelectric Plate

A wave-based design of semi-active piezoelectric composites for broadband vibration control

Locally Resonant Periodic Wave Barriers for Vibration Isolation in Subway Engineering

Tunable Band Gaps and Transmission Behavior of SH Waves with Oblique Incident Angle in Periodic Dielectric Elastomer Laminates

Band Gaps of Lamb Waves in One-Dimensional Piezoelectric Composite Plates: Effect of Substrate and Boundary Conditions

Surface wave mitigation by periodic wave barriers under a moving load: theoretical analysis, numerical simulation and experimental validation

Vibration isolation of infinitely periodic pile barriers for anti-plane shear waves: An exact series solution

Phonon-polariton and band structure of electro-magneto-acoustic SH wave propagation oblique to the periodic layered piezoelectric structures