Abstract:Recently, the study on elastic waves in phononic crystal plates is becoming a research hotspot due to its potential applications, especially in wireless communication, transducer and sensor system [1-10]. The phononic crystal plates commonly consist of two materials with large contrast in elastic properties and densities, arranging in a periodic (or quasiperiodic) array. The absolute band gaps in composite plates can forbid the propagation of all elastic wave modes in all directions. Comparing with the bulk wave and surface acoustic wave devices, phononic crystal plates have better performance in elastic wave propagation since the phase speed of most Lamb wave modes (except for A0 mode) is faster than surface wave mode, and also the wave energy in plates is totally confined between the upper and nether free-stress boundaries regardless of the air damp and self-dissipation, which provides a special potentiality in micro-electronics in wireless communication. The propagation of Lamb waves is much more complicated than bulk wave and surface acoustic wave in terms of the free-stress boundaries which can couple the longitudinal and transversal strain components. The first attempt to describe the propagation of Lamb waves with wavelength comparable with the lattice is due to Auld and co-workers [11-12], who studied 2D composites within the couple-mode approximation. Alippi et al. [13] have presented an experimental study on the stopband phenomenon of lowest-order Lamb waves in piezoelectric periodic composite plates and interpreted their results in terms of a theoretical model, which provides approximate dispersion curves of the lowest Lamb waves in the frequency range below the first thickness mode by assuming no coupling between different Lamb modes. The transmissivity of the finite structure to Lamb wave modes was also calculated by taking into account the effective plate velocities of the two constituent materials [14]. Based on a rigorous theory of elastic wave, Chen et al.[1] have employed plane wave expansion (PWE) method and transient response analysis (TRA) to demonstrate the existence of stop bands for lower-order Lamb wave modes in 1D plate. Gao et al.[8] have developed a virtual plane wave expansion (V-PWE) method to study the substrate effect on the band gaps of lower-order Lamb waves propagating in thin plate with 1D phononic crystal coated on uniform substrate. They also studied the quasiperiodic (Fibonacci system) 1D system and find out the existence of split in phonon band gap [2]. In order to reduce the computational complexity without losing the accuracy, Zhu et al.[9] have promoted an efficient method named harmony response analysis (HRA) and supercell plane wave expansion (SC PWE) to study the behavior of Lamb wave in silicon-based 1D composite plates. Zou et al.[10] have employed V-PWE method to study the band gaps of plate-mode waves in 1D piezoelectric composite plates with substrates.

Elastic Wave Band Structures and Defect States in A Periodically Corrugated Piezoelectric Plate

Exact Solution to Band Structures of One-Dimensional Viscoelastic Functionally Graded Phononic Crystals

Symmetry Breaking Induces Band Gaps in Periodic Piezoelectric Plates

Defect Mode-Induced Unidirectional Flexural Wave Transmission Using Prismatic Beams with Concentrated Gradient Masses

Applying Bandgap Defect Modes to Crack Detection in Beams Using Periodic Concentrated Masses

Band Gaps of Lamb Waves in One-Dimensional Piezoelectric Composite Plates: Effect of Substrate and Boundary Conditions

Bandgap Structures Of Sh-Wave In A One-Dimensional Phononic Crystal With Viscoelastic Interfaces

Control of the Elastic Wave Bandgaps in Two-Dimensional Piezoelectric Periodic Structures

Acoustic Band Pinning in the Phononic Crystal Plates of Anti-Symmetric Structure

Acoustic Waves In Phononic Crystal Plates

Bulk wave propagation in layered piezomagnetic/piezoelectric plates with initial stresses or interface imperfections

The band structures of guided waves in periodically piezoelectric composite plate with a mirror plane (Conference Presentation)

Stable Elastic Wave Band-Gaps of Phononic Crystals with Hyperelastic Transformation Materials

Theoretical analysis of guided waves propagation in periodic piezoelectric plates with shunting circuits

COUPLED BAND GAPS IN THE PIEZOELECTRIC COMPOSITE PLATE WITH INTERCONNECTED ELECTRIC IMPEDANCE

Bandgap Calculation and Experimental Analysis of Piezoelectric Phononic Crystals Based on Partial Differential Equations

Tunable Bandgaps of Guided Waves by Periodic Shunting Circuits in Multilayered Piezoelectric Plates

Piezoelectric-sensitive mode of lamb wave in one-dimensional piezoelectric phononic crystal plate

Broadband controllable defect state of longitudinal waves in one-dimensional pillared phononic crystal beams

Investigation of Bandgap Properties of a Piezoelectric Phononic Crystal Plate Based on the PDE Module in COMSOL

In-plane elastic waves in piezoelectric metamaterials with Parity–Time symmetry