Abstract:Laser powder bed fusion (LPBF) uses a focused, high power laser to repeatedly scan geometric patterns on thin layers of metal powder, which build up to a final, solid three-dimensional (3D) part. This process is somewhat limited in that the parts tend to have poorer surface finish (compared to machining or grinding) and distortion due to residual stress, as well as multiple other deficiencies. Typical laser scan strategies are relatively simple and use constant laser power levels. This elicits local variations in the melt pool size, shape, or temperature, particularly near sharp geometric features or overhang structures due to the relatively higher thermal conductivity of solid metal compared to metal powder. In this paper, we present a new laser power control algorithm, which scales the laser power to a value called the geometric conductance factor (GCF). The GCF is calculated based on the amount of solid vs. powder material near the melt pool. The algorithm for calculating GCF is presented along with some basic examples for clarification. Then, we detail the hardware and software implementation on the National Institute of Standards and Technology (NIST) additive manufacturing metrology testbed (AMMT), which includes co-axial melt pool monitoring using a high-speed camera. Six parts were fabricated out of nickel superalloy 625 (IN625) with the same nominal laser power, but with varying GCF algorithm parameters. We demonstrate the effect of tailored laser power on reducing the variability of melt pool intensity measured throughout the 3D build. Finally, we contrast the difference between the 'optimized' part vs. the standard build parameters, including the deflection of the final part top surface near the overhang and the variation of surface finish on the down-facing surfaces. Ultimately, the improvements to the in-situ process monitoring and part qualities demonstrate the utility and future potential tuning and optimizing more complex laser scan strategies.

Real-Time Image-Based Feedback Control of Laser Powder Bed Fusion

An empirical model for feedforward control of laser powder bed fusion

Layer-to-Layer Melt Pool Control in Laser Powder Bed Fusion

A novel paradigm for feedback control in LPBF: layer-wise correction for overhang structures

Multiple Sensor Detection of Process Phenomena in Laser Powder Bed Fusion

Model Predictive Control of Melt Pool Size for the Laser Powder Bed Fusion Process Under Process Uncertainty

In-situ Controller Autotuning by Bayesian Optimization for Closed-loop Feedback Control of Laser Powder Bed Fusion Process

Linear Active Disturbance Rejection Control for a Laser Powder Bed Fusion Additive Manufacturing Process

Thermal Based Process Monitoring for Laser Powder Bed Fusion (LPBF)

Monitoring of Single-Track Melting States Based on Photodiode Signal during Laser Powder Bed Fusion

Part geometry and conduction-based laser power control for powder bed fusion additive manufacturing

Continuous Comprehensive Monitoring of Melt Pool Morphology Under Realistic Printing Scenarios with Laser Powder Bed Fusion

Particle tracking in a simulated melt pool of laser powder bed fusion

Finite element modeling of melt pool dynamics in laser powder bed fusion of 316L stainless steel

Model predictive control of laser metal deposition

Online in-situ monitoring of melt pool characteristic based on a single high-speed camera in laser powder bed fusion process

Control-Oriented Modeling and Layer-to-Layer Spatial Control of Powder Bed Fusion Processes

The interplay between vapour, liquid, and solid phases in laser powder bed fusion

A three-phase model for simulation of heat transfer and melt pool behaviour in laser powder bed fusion process

A rapid experimental workflow for studying melt track scaling in laser powder bed fusion using high-precision metal template substrates

Real-time monitoring of laser powder bed fusion process using high-speed X-ray imaging and diffraction