Abstract:To clarify the CO-tolerant mechanism at Pt-based alloy anode catalysts, surface-enhanced infrared reflection-absorption spectroscopy with the attenuated total reflection technique(ATR-SEIRAS), coupled with CV measurement, was used to observe the oxidation process of adsorbed CO on a typical Pt-Fe (Pt-Fe = 0.27/0.73) alloy. The alloy electrode exhibits a lower saturated coverage of CO.(theta(CO) = 0.55) than that of pure Pt (theta(CO) = 1.0). The dominating linear CO is observed around 2000 cm(-1) when the equilibrium adlayer of CO covers the alloy electrode; however, linear and bridged CO and also GOON were found at the pure Pt electrode at the same CO coverage in the non-steady-state, On the basis of our previous results that a Pt skin is formed during the repetitive potential cycling due to the dissolution of Fe on the alloy surface and the skin exhibits less electronic density in the d band, it can be explained that the lowered linear CO coverage and almost no bridged CO are obtained as the result of the lowered back-donation of d electrons from the Pt skin to adsorbates on the alloy surface. The wavenumber shift of the linear CO stretching to a lower value at the alloy, which is not simply predicted by the lowering of the back-donation of the d electron, is ascribed to the weakening of the C-Pt bond. As a presumable effect of the electronic structure change at the Pt skin, the dissociation-oxidation of adsorbed water as well as a formation of adsorbed HOOH species are clearly observed beyond 0.6 V in the electrolyte solution without CO, which is different from that at the pure Pt electrode. Carbonate species can also be detected around 1300-1450cm(-1), which are possibly produced by the surface-reaction of CO2 with water.

Electrocatalysis of the Cathodic Reduction of Carbon Dioxide on Platinized Titanium Dioxide Film Electrodes

Electrocatalysis of Oxygen Reduction on Carbon-Supported PtCo Catalysts Prepared by Water-in-oil Micro-Emulsion

Photothermal Catalysis for Selective CO2 Reduction on the Modified Anatase TiO2 (101) Surface

A novel fabrication of RuO2/TiO2 nanofilms for electrocatalytic reduction of CO2

Understanding Trends in Electrochemical Carbon Dioxide Reduction Rates

(Photo)electrocatalytic CO2 Reduction at the Defective Anatase TiO2 (101) Surface

Oxidation of Carbon Monoxide at a Platinum Film Electrode Studied by Fourier Transform Infrared Spectroscopy with Attenuated Total Reflection Technique

Electrodeposition of RuO2 Layers on TiO2 Nanotube Array Toward CO2 Electroreduction

CO2 Activation and Reduction on Pt-CeO2 Based Catalysts

Oxidation of CO on a Pt−Fe Alloy Electrode Studied by Surface Enhanced Infrared Reflection−Absorption Spectroscopy

Electrocatalysis of Anodic Oxygen‐Transfer Reactions: Titanium Substrates for Pure and Doped Lead Dioxide Films

Electrochemical Reduction of CO2 on RuO2/TiO2 Nanotubes Composite Modified Pt Electrode

In Situ Infrared Spectroscopic Investigations of Pyridine-Mediated CO2 Reduction on Pt Electrocatalysts

Oxidation of Platinum Surfaces and Reaction with Carbon Monoxide

Photocatalytic CO2 Reduction and Electrocatalytic H2 Evolution over Pt(0,II,IV)-Loaded Oxidized Ti Sheets

Quantifying Oxidation Rates of Carbon Monoxide on a Pt/C Electrode

Electrocatalytic CO 2 Reduction: Monitoring of Catalytically Active, Downgraded, and Upgraded Cobalt Complexes

Unique Electrochemical Catalytic Behavior of Pt Nanoparticles Deposited on TiO2 Nanotubes

Photoelectrocatalytic Reduction Of Co2 Into Chemicals Using Pt-Modified Reduced Graphene Oxide Combined With Pt-Modified Tio2 Nanotubes

CO2 dissociation activated through electron attachment on reduced rutile TiO2(110)-1x1 surface

Electroreduction of Oxygen at A Pt/C-Modified Electrode with A Cobaltporphyrin Complex