Abstract:Growing usage of lightweight materials such as Al and Mg alloys in automotive body manufacture has come to a point that bonding of dissimilar materials is a realistic problem to address. A significant issue related to the bonding of dissimilar materials is that the differences in substrate surface conditions and substrate strengths often lead the bond to fail at strength far less than the bond strength established by adhesive manufacturer for a balanced joint. This research experimentally studied several factors potentially influencing initial strengths and debonding modes of adhesively-bonded Al-steel joints using single lap-shear coupons with comparison to like-substrate joints. Three commonly-used SLS coupon fabricating processes were investigated to determine which provided consistent bond strength and was efficient in making large quantities of coupons for the subsequent study. Next, the effect of prelube on the initial bond strength and debonding mode was investigated since the amount of prelube varies from sheet to sheet in automotive production. It was observed that even a very small change in the amount of prelube being applied on Al affected the initial bond strength. The more the prelube the weaker the bond became and the more adhesive failure occurred on the bonded Al surface. On the other hand, varying amount of the mill oil on the steel surface did not make much change to the bonding strength. Finally, various combinations of Al and steel substrates were studied to observe the effect of substrate materials on the initial bond strength and failure behavior. It revealed that the strength of joints between a relatively strong substrate and a relatively weak substrate fell below the strength of identical material joint made of the relatively strong substrate, and was closer to the strength of identical material joint made of the relatively weak substrate. For bonds having a high joint efficiency, adhesive failures were observed mostly on the surfaces of relatively weak substrates in the dissimilar material bonds due to large deformation in the weak substrate resulting in higher loading on that interface.

Investigation on Delamination Characteristics of 2-Ply Clad Metals and Adhesive Joints for Aluminum/Stainless Steel via the Peel Test

Experimental Investigation of the Mechanical Behavior of Aluminum Adhesive Joints under Mixed-Mode Loading Conditions

Effect Of Prelube, Surface Coating And Substrate Materials On Initial Strength Of Adhesive Joints Between Al Alloy And Steels

Research on the Secondary Bending of Composite-metal Adhesively Bonded Joints

Experimental Study of Initial Strengths and Hygrothermal Degradation of Adhesive Joints Between Thin Aluminum and Steel Substrates

Study on 180o Peel Test of Interface Adhesive Honeycomb Sandwich Structure

Effect of adherend deflection on lap-shear tensile strength of laser-treated adhesive-bonded joints

Study on Effects of Pre-Treatment and Surface Roughness on Tensile-Shear Strength of 2060 Al–Li Alloy Adhesive Joints

Investigation on Bonding Strength of Steel/Aluminum Clad Sheet Processed by Horizontal Twin-Roll Casting, Annealing and Cold Rolling

Investigation of Deformation Behavior During Cold Rolling Cladding Process of Four-Layer Composite Aluminum Alloys

The effect of adhesive bonding between aluminum and composite prepreg on the mechanical properties of carbon-fiber-reinforced metal laminates

Tensile-shear properties of steel-Al adhesively bonded dissimilar joints and the effect of Al plate thickness

Effect of adhesive characteristics on static strength of adhesive-bonded aluminum alloys

Interfacial stress analysis of a thin plate bonded to a rigid substrate and subjected to inclined loading

On the Mechanical Properties Detection Technology and Analysis of Composite Laminated Plate with Single-Lap Adhesive Bonding

Effect of Base Steels on Mechanical Behavior of Adhesive Joints with Dissimilar Steel Substrates

Curing-Induced Debonding and Its Influence on Strength of Adhesively Bonded Joints of Dissimilar Materials

Tension Assisted Peeling

Investigation on shear and fatigue performance of CFRP/aluminum alloy single-lap adhesive joint

Investigation of analysis and improvement of the assessment of bonding performance for thermoplastic composites

HOT ROLL BONDING OF ALUMINUM FLAT COMPOSITE MATERIAL WITH STEEL MESH INLAYS