Abstract:Direct torque control (DTC) is a widely used approach for motor drives due to its distinctive advantages, e.g., fast dynamic response and highly robust against motor parameters uncertainties and external disturbances. To achieve a lower torque ripple, a higher switching frequency is usually required, which, however, can reduce the drive efficiency. Using the emerging silicon carbide (SiC) devices, which can operate efficiently at a much higher switching frequency than their silicon counterparts, thus, it could be feasible to achieve high efficiency and low torque ripple simultaneously. In this work, a novel multilevel DTC for a SiC T-type inverter is proposed to significantly reduce the torque and flux ripples while retaining the fast-dynamic response. The unbalanced dc-link is a common issue of the T-type inverter, which may also lead to a higher torque ripple. To address this issue, the proposed DTC algorithm only uses the real voltage space vectors and virtual space vectors (VSVs) that do not contribute to the neutral point current such that an inherent dc-link capacitor voltage balancing can be achieved without using any active dc-link voltage controls or additional dc-link voltage and/or current sensors. The feasibility and effectiveness of proposed methods are verified by using both simulation and experimental studies.

T-Type Multi-Inverter Application for Traction Motor Control

Multilevel inverter application for railway traction motor control

Direct Torque Control of the Induction Motor Fed with a Three-Level Inverter

Three-level Inverter and Induction Machine's SVV Control Technology and Its Simulation

A Dual Three-Level T-NPC Inverter for High-Power Traction Applications

Drive Control of a Permanent Magnet Synchronous Motor Fed by a Multi-level Inverter for Electric Vehicle Application

Direct Torque Control of Induction Motor Fed by Three Level Inverter (I)--Single Vector Method

Realization of A Spwm Inverter for Multi-Phase Induction Motor Drives

Simulation Software for Crh2 and Crh3 Traction Driver Systems Based on Simulink and Vc

A Control Scheme for a High Speed Railway Traction System Based on High Power PMSM

Speed Sensorless Direct Torque Control of 3-Level Inverter-Fed Induction Motor Drive Based on Optimized Switching Table

A Novel Control Scheme for Traction Inverters in Electric Vehicles With an Optimal Efficiency Across the Entire Speed Range

A V/Hz Based Maximum Torque Per Volt Control in Flux-Weakening Region for Interior Permanent Magnet Synchronous Motors

A Novel Modulation Scheme and a DC-Link Voltage Balancing Control Strategy for T-Type H-Bridge Cascaded Multilevel Converters

Enhanced Direct Torque Control for a Three-Level T-Type Inverter

A Direct Torque Control of Induction Motor Based on Three-Level NPC Inverter

Direct torque control of induction motor fed by three level inverter (II) - Method of synthesizing vectors

Implementation of Direct Torque Control with Gto Inverter for Locomotive Drives

Research on Three-Level Inverter of Six-Phase Synchronous Motor

Control strategies of direct torque control of induction motor applied to traction

High Performance Three-Level Induction Motor Drive System