Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

Signal Estimation for Vehicle Body Accelerations Using Piecewise Linear System Identification in the Frequency Domain

Robust and Efficient Vehicles Motion Estimation with Low-Cost Multi-Camera and Odometer-Gyroscope

Combined Estimation of Vehicle Body State and Sprung Mass Based on Electronically Controlled Air Suspension System

Design of a Capacitive Flexible Weighing Sensor for Vehicle WIM System

Urban rail track condition monitoring based on in-service vehicle acceleration measurements

Vehicle sideslip angle estimation for a four-wheel-independent-drive electric vehicle based on a hybrid estimator and a moving polynomial Kalman smoother

Sensor fault detection of vehicle suspension systems based on transmissibility operators and Neyman–Pearson test

A Robust Unscented M-Estimation-Based Filter for Vehicle State Estimation with Unknown Input

Identification of track irregularities with the multi-sensor acceleration measurements of vehicle dynamic responses

Vehicle mass estimation based on high-frequency-information extraction ?

Real-Time Estimation Of Vehicle'S Lateral Dynamics At Inclined Road Employing Extended Kalman Filter

Dynamic Parameter Estimation of Velocity Sensors Using an Indirect Measurement Approach

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

A Hybrid Data-driven Soft Sensor Framework for Torque Estimation

State Estimation Using Single Body-Frame Bearing Measurements

Fuzzy Adaptive State Estimation of Distributed Drive Electric Vehicles with Random Missing Measurements and Unknown Process Noise

Adaptive Estimations of Tyre–road Friction Coefficient and Body’s Sideslip Angle Based on Strong Tracking and Interactive Multiple Model Theories

Exploration of Vibration Signal Measurement Method of Automobile Parts Utilizing FPGA/Photoelectric Sensor

Fatigue monitoring and maneuver identification for vehicle fleets using a virtual sensing approach

IDENTIFICATION OF SYSTEM PHYSICAL PARAMETERS FOR VEHICLE SYSTEMS WITH NONLINEAR COMPONENTS

Advanced Estimation Techniques for Vehicle System Dynamic State: A Survey