Abstract:The characteristics of nanomaterials have garnered significant attention in recent research on natural and forced convection. This study focuses on the forced convection characteristics of ternary nanofluids within convergent and divergent channels. The ternary nanofluid comprises titanium oxide (TiO2), zinc oxide (ZnO), and silver suspended in water, which serves as the base fluid. Using COMSOL Multiphysics 6.0, a reliable software for finite element analysis, numerical simulations were conducted for steady and incompressible two-dimensional flow. Reynolds numbers varying from 100 to 800 were employed to investigate forced convection. Additionally, we explored aspect ratios (channel height divided by the height of the convergent or divergent section) of -0.4, -0.2, 0, 0.2, and 0.4. Our findings revealed that only at aspect ratio a = 0.4 did the average outlet temperature increase as the Reynolds number rose, while other aspect ratios exhibited decreasing average temperatures with declining Reynolds numbers. Moreover, as the Reynolds number increased from 100 to 800 and the total volume fraction of the ternary nanofluids ranged from 0.003 to 0.15, there was a significant 100% enhancement in the average Nusselt number. For clarity, this article briefly presents essential information, such as the study's numerical nature, fluid properties (constant-property fluid), and the methodology (COMSOL Multiphysics 6.0, finite element analysis). Key conclusions are highlighted to enable readers to grasp the main outcomes at a glance. These details are also adequately covered in the manuscript to facilitate a comprehensive understanding of the research. The utilization of this emerging phenomenon holds immense potential in various applications, ranging from the development of highly efficient heat exchangers to the optimization of thermal energy systems. This phenomenon can be harnessed in scenarios in which effective cost management in thermal production is a critical consideration.

Falling film evaporation of ternary mixture under three different modes of heating

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Evaporation of Water Film in a Three-Dimensional Vertical Rectangular Channel by Laminar Mixed Convection

Numerical simulation of falling film evaporation of binary mixture

A Molecular Dynamics Investigation on Evaporation of Thin Liquid Films

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Thermodynamic analysis in laminar falling film evaporator

Numerical investigation of effective parameters of falling film evaporation in a vertical‐tube evaporator

Mass Transfer During Falling Film Evaporation Based on New Multi-Stage Flash Model

Effect of evaporation rate for the heat and mass transfer of the laminar liquid falling film in still air

Falling Film Evaporation in a Triangular Tube Bundle under the Influence of Cross Vapor Stream

Falling film flow and heat transfer on a horizontal tube under the shearing of vertical vapor

Numerical simulation of the behavior of falling films on horizontal plain tubes

Three-dimensional heat transfer coefficient distributions in horizontal tube falling film evaporation

Numerical investigation of heat transfer and fluid flow characteristics of ternary nanofluids through convergent and divergent channels

Heat and mass transfer of ternary nanofluid in permeable vertical channel sandwiched between nanofluid zones with Soret and Dufour effects using sensitivity analysis

The stability analysis of volatile liquid films in different evaporation regimes

Condensation and evaporation of binary droplets with internal mass transfer

STUDY ON EVAPORATIVE COOLING OF FALLING FILM COUPLED WITH HEAT AND MASS TRANSFER

Numerical investigation of heat and mass transfer from an evaporating meniscus in a heated open groove

Evaporation of an R114/R21 falling liquid film: Experimental studies and modelling