Abstract:Abstract Useful thermal bridge performance indicators (ITBs) of existing buildings may differ from calculated thermal bridge performance derived theoretically due to actual construction conditions, such as irregular shapes and aging. To fill this gap practically, a more realistic quantitative evaluation of thermal bridge on-site needs to be considered to identify thermal behaviors throughout exterior walls and thus improve the overall insulation performance of buildings. In this study, a case study is conducted using an infrared thermal imaging method to evaluate the thermal bridge of an existing building practically. The study's main purpose is to review the thermal bridge performance indicators measured by the steady-state model under field conditions in terms of convergence and uncertainty. Bayesian Markov Chain Monte Carlo (MCMC) is used to examine the validity of the results by deriving evaluation results in the form of distribution, including uncertainty. After the measurement was completed, an analysis of the results was conducted. As a result of measurement for 3 days, it was found that the thermal bridge part had 1.221 times more heat loss than the non-thermal bridge part, which showed a 6.7% deviation from the numerical method. However, the uncertainty was 0.225 (18.4%, CI 95%), a large figure. This is due to the influence of field conditions and shows the limitations of the steady-state measurement model. Regarding the convergence of the results, the measurement results were found to converge continuously as the measurement time increased. This suggests that valid results can be obtained in the field if the measurement is performed for a sufficient time, even with a thermal bridge measurement method assuming a steady-state.

A Study on Estimation Model of Incidence Factor of the Thermal Bridge Using In-Situ Measurement Infrared Thermography

In-Situ Thermal Bridge Evaluation of a Building Using Bayesian Inference With Measured Infrared Thermography

Methods for Evaluating and Improving Thermal Performance of Wall-to-floor Thermal Bridges

An Efficient Temperature Calibration Method Based on the Improved Infrared Forward Model and Bayesian Inference

Heat and Moisture Transfer in Wall-to-floor Thermal Bridges and Its Influence on Thermal Performance

Finite Element Analysis of 3D Heat Transfer of Typical Thermal Bridge of Self-Thermal Insulation in Hot-Summer and Cold-Winter Zone

Analysis of Multi-Factor on Measurement Improvement of an Infrared Imager in Low-Temperature Environments

Appropriate conditions for determining the temperature difference ratio via infrared camera

Strain-temperature Correlation Analysis of a Tied Arch Bridge Using Monitoring Data

A New Method of Pixel-level In-situ U-value Measurement for Building Envelopes Based on Infrared Thermography

Influences of Average Temperature Difference and Measurement Period on Estimation of In Situ Thermal Transmittance of Building Exterior Walls Using the Average Method of ISO 9869-1

Moisture Distribution in Wall-to-floor Thermal Bridges under the Analysis of Coupled Heat and Moisture Transfer

The Method of Reducing Heat Loss from Thermal Bridges in Residential Buildings with Internal Insulation in the Hot Summer and Cold Winter Zone of China

Quantitative thermography for the estimation of the U-value: state of the art and a case study

Non-Destructive Possibilities of Thermal Performance Evaluation of the External Walls

A Soft Calibration Technique for Infrared Imaging Based on Physical Model of Thermal Radiation and Variational Bayesian Inference from Small Dataset

In-situ measurement of thermal transmittance of building walls: Evaluation of stored heat flux in heavy-weight walls during the cooling season

Quantitative internal infrared thermography for determining in-situ thermal behaviour of façades

Estimation of the thermal properties of an historic building wall by combining Modal Identification Method and Optimal Experiment Design

Numerical analysis and experimental investigation on thermal bridge effect of vacuum insulation panel

Equivalent Slabs Approach to Simulate the Thermal Performance of Thermal Bridges in Building Constructions