Abstract:Cellulose nanocrystal and chitosan blended Nanocomposite for dye removal. Development of a cost‐effective and environmentally friendly method to treat dye wastewater is of utmost importance. In this experimental study, wastepaper was used as the raw material for the extraction of cellulose nanocrystals to fabricate a nanocomposite membrane with chitosan. During the extraction process, acid hydrolysis (Sulfuric acid) followed by bleaching (hydrogen peroxide) was adopted. To confirm the nano‐range, particle size analysis, and FESEM were performed, which confirmed the presence of particles in the nano‐range ranging from 313.8 to 122.1 nm and FESEM observed results showed transformation of fibrous to rod shaped nanocrystals after acid hydrolysis. After successful nanocomposite fabrication a porous sieved network of membrane was observed and after adsorption successful adhesion of dye molecules over the membrane matrix was also confirmed. FTIR data showed that during adsorption mechanism some of the prominent peaks gets disappeared suggest interaction of dye molecules onto the nanocomposite. The contact angle of 21.0° was observed for the ChNC3 nanocomposite showed super hydrophilic behavior. Tensile strength was also observed in terms of young's modulus, ultimate strength, and elongation at break. The elasticity and stiffness of a material are usually indicated by its young modulus. In AH CNCs and ChNC3, the young modulus was seen to be increasing from 195 0.316, respectively. Furthermore, the potentiality of the nanocomposite membrane was analyzed for Congo red dye in synthetic wastewater prepared in the laboratory. During the batch study, various working parameters were taken such as initial dye solution (20–100 ppm), pH (1–7), contact time (10–60 min), and dosage (0.1–0.5 mg/L). To know about adsorption, Langmuir and Freundlich isotherm were analyzed it was observed that Freundlich isotherm show best fitted modeling with R2 = 0.99, and n = 1.6 showing favorability of the heterogeneous adsorption. To determine the interaction between the adsorbate and adsorbent, pseudo first order and pseudo second order kinetics models were analyzed, and it was observed that chemisorption interaction followed between the adsorbate and adsorbent. Thermodynamic parameters were analyzed, which confirmed the spontaneous and favorable adsorption mechanism. To avoid fouling problems and maintain cost effectiveness, the resulting, nanocomposite membrane was desorbed using an appropriate solvent. After 5 cycles, the desorption rate decreased from 54% to 38%. This developed nanocomposite membrane appears to be effective in effluent waste treatment because of its simple formulation approach.

Recent advances in removal of Congo Red dye by adsorption using an industrial waste

Studies on the Removal of Congo Red Dye by an Adsorbent Based on Fly-ash@Fe3O4 Mixture

Utilization of chemically modified coal fly ash as cost-effective adsorbent for removal of hazardous organic wastes

ADSORPTION OF BEMACID RED DYE FROM AQUEOUS SOLUTIONS ON COAL FLY ASH MODIFIED WITH HYDROCHLORIC ACID

Rapid Removal of Dyes by Carbonized Sludge: Process, Effects of Environmental Factors, and Mechanism

Treatment of Water Containing Dyes Using Cellulose Aerogels

Kinetic studies of Congo red dye adsorption by immobilized Aspergillus niger on alginate

Cellulose–kaolin incorporated polymeric hydrogels and its application for dye removal: batch study and mechanism

CRAB SHELL: A POTENTIAL HIGH-EFFICIENCY AND LOW-COST ADSORBENT FOR DYE WASTEWATER

Recent Advances in Utilizing Lignocellulosic Biomass Materials as Adsorbents for Textile Dye Removal: A Comprehensive Review

Adsorption of congo red dye from aqueous solutions by prepared activated carbon with oxygen-containing functional groups and its regeneration

Fabrication of a corn stalk derived cellulose-based bio-adsorbent to remove Congo red from wastewater: Investigation on its ultra-high adsorption performance and mechanism

Adsorption enhancement of Congo red dye from wastewater based on edamame shell originated activated carbon by the cations: Experimental and theoretical studies

Coal fly ash as adsorptive material for treatment of a real textile effluent: operating parameters and treatment efficiency

Bio-based composite from chitosan waste and clay for effective removal of Congo red dye from contaminated water: Experimental studies and theoretical insights

Bentonite blended with bagasse ash as an adsorbent for reactive red 198 dyes

Adsorption of congo red and methylene blue dyes on an ashitaba waste and a walnut shell-based activated carbon from aqueous solutions: Experiments, characterization and physical interpretations

Performance Evaluation of Carbonized Vermiculite–Polycarbonate Nanofibrous Adsorbent for Congo Red Removal

Waste to wealth: Facile activation of red mud waste and insights into industrial reactive dye removal from wastewater

Novel wastepaper nanocellulose/chitosan‐based nanocomposite membrane for effective removal of the textile dye Congo red from aqueous solution

Comparative study on efficiency of surface enhanced coal fly ash and raw coal fly ash for the removal of hazardous dyes in wastewater: optimization through response surface methodology