Abstract:ABSTRACT The focus of this paper is on the modelling of miniature electromechanical actuators used in a morphing wing application, on the development of a control concept for these actuators, and on the experimental validation of the designed control system integrated in the morphing wing-tip model for a real aircraft. The assembled actuator includes as its main component a brushless direct current motor coupled to a trapezoidal screw by using a gearing system. A Linear Variable Differential Transformer (LVDT) is attached on each actuator giving back the actuator position in millimetres for the control system, while an encoder placed inside the motor provides the position of the motor shaft. Two actuation lines, each with two actuators, are integrated inside the wing model to change its shape. For the experimental model, a full-scaled portion of an aircraft wing tip is used with the chord length of 1.5 meters and equipped on the upper surface with a flexible skin made of composite fibre materials. A controllable voltage provided by a power amplifier is used to drive the actuator system. In this way, three control loops are designed and implemented, one to control the torque and the other two to control the position in a parallel architecture. The parallel position control loops use feedback signals from different sources. For the first position control loop, the feedback signal is provided by the integrated encoder, while for the second one, the feedback signal comes from the LVDT. For the experimental model, the parameters for the torque control, but also for the position control-based encoder signal, are implemented in the power amplifier energising the electrical motor. On the other hand, a National Instruments real-time system is used to implement and test the position control-based LVDT signal. The experimental validation of the developed control system is realised in two independent steps: bench testing with no airflow and wind-tunnel testing. The pressure data provided by a number of Kulite sensors equipping the flexible skin upper surface and the infrared thermography camera visualisations are used to estimate the laminar-to-turbulent transition point position.

Three-axis control of tailless aircraft using fluidic actuators: MAGMA case study

A Minimal Thrust Vectoring Rotor with Six Degree of Freedom: Design and Analysis

A Novel Control Allocation Method for Yaw Control of Tailless Aircraft

Unsteady Flow Simulation of a Variable-Sweep Morphing Aircraft Coupled with Flight Control System

A 5-Phase Fault-Tolerant Brushless Permanent Magnet Motor Drive for an Aircraft Thin Wing Surface Actuator

Virtual flight test of pitch and roll attitude control based on circulation control of tailless flying wing aircraft without rudders

Adaptive Control of Novel Configuration with Moving Mass

Design of a multi-vectored thrust aerostat with a reconfigurable control system

Flow Control with Synthetic Jets on two Tandem Airfoils Using Machine Learning

Feedback and Control of Linear Electromagnetic Actuators for Flapping Wing MAVs

Attitude control system for a lightweight flapping wing MAV

Flight Control Using Only Synthetic Jet Actuators In High-Angle-Of-Attack

Aerodynamic drag reduction of a tilt rotor aircraft using zero-net-mass-flux devices

Experimental Validation of an Effective Control Mechanism to Enable Flapping Wing Rotor Stable Flight

A new hybrid control methodology for a morphing aircraft wing-tip actuation mechanism

Numerical Investigation on Aerodynamic Characteristics of an Active Jets-Matrix Serving as Pitch Control Surface

Flight Controller Design and Demonstration of a Thrust-Vectored Tailsitter

Fluidic Flow Control Devices for Gust Load Alleviation

Fuzzy Logic-Based Control for a Morphing Wing Tip Actuation System: Design, Numerical Simulation, and Wind Tunnel Experimental Testing

Model and longitudinal hover control of a conceptual thrust-vectored unmanned tail-sitter

Heavy Class Helicopter Fuselage Model Drag Reduction by Active Flow Control Systems