Abstract:Complex physical and mathematical concepts of quasicrystals have been applied, for the first time, to an engineering processing of an alloy containing a quasicrystalline phase. Icosahedral quasicrystals ( i -phase), which are quasiperiodic and possess fivefold symmetry, are often found as stable phase in aluminum and magnesium alloys. They are known to be hard and brittle at room temperature, therefore their deformation behavior at lower temperatures is not well understood yet. High pressure torsion (HPT) gives an opportunity to study deformation of brittle materials due to confinement of the dies. Here, we report on deformation behavior of 27 vol% eutectic i -phase present in a magnesium alloy Mg-12Zn-2Y (at%) subjected to HPT under 5 GPa pressure at RT with a number of rotations N. The matrix -Mg phase deformed by twinning and dislocation slip, leading to full recrystallization. Consequently, diffraction peaks showed broadening, followed by sharpening. The peaks of i -phase continued to broaden. Fivefold symmetry diffraction peaks broadened disproportionately to the others. Peak broadening analysis showed that deformation occurs predominantly by changes in fivefold symmetry planes, as observed to be by twinning and formation of narrow planar faults. No evidence of new random phason strains was detected. Introduction of localized phonon strain was detected at high strains, which could be correlated with creation of interfaces and surfaces by fragmentation of i -phase into nanoparticles and dispersion into the matrix. Vickers microhardness of the alloy increased from 118 Hv to over 175 Hv after N = 40.

Phason strain in the crystallization of icosahedral AlMnSi

Electron Diffraction Study Of Octagonal-Cubic Phase Transitions In Mn-Si-Al

Coexistence of Decagonal and Icosahedral Phases in Al4Mn Alloy

Direct Observation of the Transformation of the Icosahedral Phase in (al6mn)1−xsix, into Α(almnsi)

Phase stability and the interface structure of a nanoscale Si crystallite in Al-based alloys

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Computer-Simulations Of A Distorted Reciprocal Lattice Of An Al-Li-Cu Single Quasicrystal

Determination of atomic structure of phason planes in the ξ′-Al–Pd–Mn phase

Phase Transformation Between Multiply-Twined Crystal Aggregates and Decagonal Quasicrystal in an Al-Pd-Mn Alloy

Tension/Compression Difference in Creep Resistances of Wrought Mg-Zn-Based Alloy with Icosahedral Quasicrystal Phases

Mackay icosahedron explaining orientation relationship of dispersoids in aluminium alloys

Transmission Electron-Microscopy Study of Small-Angle Grain-Boundaries, Dislocations and Modulated Phases in Al-Li-Cu Quasi-Crystals

The transition from amorphous to crystalline in Al/Zr multilayers

On the characterisation of a hitherto unreported icosahedral quasicrystal phase in additively manufactured aluminium alloy AA7075

Transmission Electron Microscopy Study of the Early-Stage Precipitates in Al-Mg-Si Alloys

Deformation behavior of Mg-Zn-Y icosahedral quasicrystal phase in a magnesium matrix by high pressure torsion at room temperature

Phase Transformation Between Multiply-Twinned Crystal And Decagonal Quasicrystal In An Al-Pd-Mn Alloy

Incommensurate Modulated Structure in the Icosahedral Quasicrystalline Phase T2 of an Al-Li-Cu Alloy

FCC-Zr phase transformation-induced defect substructure in Zr2Si precipitates equilibrated in Si-modified Zircaloy-4

Five-fold symmetry structure inhibiting the growth of an otherwise perfect η 2 phase in Al-Zn-Mg-Cu alloys

From Phason Planes to Superstructures in an Al–Pd–Mn Alloy