Abstract:The development of process steps catalyzed by immobilized enzymes usually encompasses the screening of enzyme variants, as well as the optimization of immobilization protocols and process parameters. Direct immobilization of biocatalysts by physical entrapment into hydrogels can be applied to reduce the effort required for immobilization, as the enzyme-specific optimization of the immobilization procedure is omitted. Physical entrapment is applicable for purified enzymes as well as crude cell extracts. Therefore, it can be used to quickly assess and compare activities of immobilized enzymes. For the application in flow reactors, we developed 3D-printed hydrogel lattices for enzyme entrapment as well as matching housings, also manufactured by 3D-printing. Testing the resulting enzyme reactors for three different enzymes, namely alcohol dehydrogenase from Lactobacillus brevis, benzoylformate decarboxylase from Pseudomonas putida and β-galactosidase from Aspergillus oryzae, and four different enzymatic reactions showed the broad applicability of the approach but also its limitations. The activity of the immobilized biocatalysts was measured in batch experiments and compared to the kinetics of the respective free enzymes in solution. This comparison yields an effectiveness factor, which is a key figure to describe the extent the immobilized catalyst is effectively utilized. For the examined systems the effectiveness factor ranged between 6 and 14% and decreased with increasing absolute activity of the entrapped enzymes due to mass transfer limitations. To test the suitability of the hydrogel lattices for continuous operation, they were inserted into 3D-printed reactor housings and operated at constant flow. Stable product formation could be monitored over a period of 72 h for all four enzymatic systems, including two reactions with redox cofactor regeneration. Comparing calculated and experimental conversion in the continuous setup, higher values of the effectiveness factor in batch experiments also hint at good performance in continuous flow. This can be used to optimize complex biocatalytic reactions on a small scale.

Boosting the Productivity of H2-Driven Biocatalysis in a Commercial Hydrogenation Flow Reactor Using H2 From Water Electrolysis

Rapid, Heterogeneous Biocatalytic Hydrogenation and Deuteration in a Continuous Flow Reactor

Biocatalytic hydrogenations on carbon supports

H2-driven biocatalysis for flavin-dependent ene-reduction in a continuous closed-loop flow system utilizing H2 from water electrolysis

Electrocatalytic and Photocatalytic Hydrogen Evolution Integrated with Organic Oxidation.

Scalable bioreactor production of an O2‐protected [FeFe]‐ hydrogenase enables simple aerobic handling for clean chemical synthesis

Optimized Spatial Configuration of Heterogeneous Biocatalysts Maximizes Cell-Free Biosynthesis of ω-Hydroxy and ω-Amino Acids

Development and Scale-Up of a Continuous, High-Pressure, Asymmetric Hydrogenation Reaction, Workup, and Isolation

Enantiodivergent Biosynthesis of β-Hydroxy esters by Self-Sufficient Heterogeneous Biocatalysts in Continuous Flow.

Enantiodivergent biosynthesis of β-hydroxy esters by self-sufficient heterogeneous biocatalysts in a continuous flow

Highly Productive Oxidative Biocatalysis in Continuous Flow by Enhancing the Aqueous Equilibrium Solubility of Oxygen

Preparation of (3R)-quinuclidinol using heterogeneous biocatalytic hydrogenation in a dynamically-mixed continuous flow reactor

Ultrasonication-induced metabolic pathway shifts and reduced electron carrier washout with biomass enhanced hydrogen yield in a continuous stirred tank reactor

Upgrading Kolbe Electrolysis-Highly Efficient Production of Green Fuels and Solvents by Coupling Biosynthesis and Electrosynthesis

Bipolar Hydrogen Production from Biomass-Derived Aldehydes and Water in Flow Electrolyzers

Electroplated Electrodes for Continuous and Mass-Efficient Electrochemical Hydrogenation

On-the-fly H2 Degassing: Towards Selective Borohydride Reduction of Α, Β-Unsaturated Esters to Allylic Alcohols in Continuous Microflow

(Invited) Electroenzymatic Hydrogen Production: Mediated/Direct Electron Transfer Strategies and Continuous Product Analysis

H -driven xylitol production in H16

Advantages of Hydrogel-Based 3D-Printed Enzyme Reactors and Their Limitations for Biocatalysis

High-yield hydrogen production from biomass by in vitro metabolic engineering: Mixed sugars coutilization and kinetic modeling